Related papers: A two-stage time-stretching TDC with discrete comp…

The design and performance of wave union TDC implemented in a Lattice CertusPro-NX FPGA is discussed. This FPGA is available for radiation tolerant applications. The TDC is implemented with 16-channels and a 200 MHz reference clock. Each…

The aim of this study is to design and evaluate a simple free running Analog-Digital Converter (ADC) based on the Field Programmable Gate Array (FPGA) device to accomplish the energy and position readout of the silicon photomultiplier…

We present time-resolved charge sensing measurements on a GaAs double quantum dot with two proximal quantum point contact (QPC) detectors. The QPC currents are analyzed with cross-correlation techniques, which enables us to measure dot…

In this article, a time-domain calibration procedure is proposed for pulsed Terahertz Integrated Circuits (TIC) used in on-chip applications, where the conventional calibration methods are not applicable. The proposed post-detection method…

Transition-edge sensors (TESs) are sensitive devices for detecting photons from millimeter radiation to gamma rays. Their photon counting efficiency and collecting area benefit from large-array multiplexing scheme, and therefore the…

We report an optically modulated experimental realization of a photonic time crystal (PTC) in the microwave regime, demonstrating for the first time that the PTC exponential growth can overcome losses and finite-size constraints of a…

Comparators are utilised by Nyquist-rate and oversampling analog to digital converters (ADCs) to accomplish quantization and perhaps sampling. Thus, comparators have a substantial effect on the speed and accuracy of ADCs. This study…

We have developed a new laser-based time calibration system for highly segmented scintillator counters like the MEG II pixelated Timing Counter (pTC), consisting of 512-centimeter scale scintillator counters read out by silicon…

A new application-specific integrated circuit (ASIC), the high-speed charge-to-time converter (QTC) IWATSU CLC101, provides three channels, each consisting of preamplifier, discriminator, low-pass filter, and charge integration circuitry,…

Flash Analog to Digital Convertor (FADC) is frequently used in nuclear and particle physics experiments, often as the major component in big multi-channel systems. The large data volume makes the optimization of operating parameters…

Time-tagging units and coincidence detectors are used in many scientific research fields. The required timing resolution and number of input channels are varying, but some emerging experiments in the field of quantum optics require up to 32…

Clock synchronization procedures are mandatory in most physical experiments where event fragments are readout by spatially dislocated sensors and must be glued together to reconstruct key parameters (e.g. energy, interaction vertex etc.) of…

Two-channel modulo analog-to-digital converters (ADCs) enable high-dynamic-range signal sensing at the Nyquist rate per channel, but existing designs quantise both channel outputs independently, incurring redundant bitrate costs. This paper…

In this contribution, it is proposes to limit the quantization search space of a successive approximation analog-to-digital converter through an analytic derivation of maximum possible sample-to-sample variation. The presented example…

The term two-dimensional coherent spectroscopy (2DCS) usually refers to experimental setups where a coherently generated electric field in a sample is recorded over many runs as a function of two time variables: the delay $\tau$ between two…

We present the timing characteristics of the flash ADC readout of the GlueX forward calorimeter, which depends on precise measurement of arrival time of pulses from FEU 84-3 photomultiplier tubes to suppress backgrounds. The tests presented…

Analog-to-digital converters (ADCs) allow physical signals to be processed using digital hardware. Their conversion consists of two stages: Sampling, which maps a continuous-time signal into discrete-time, and quantization, i.e.,…

Model Predictive Control (MPC) is a powerful control strategy for power electronics, but it highly relies on manually-derived and topology-specific analytical models, which is labor-intensive and time-consuming in practical designs. To…

The prototype of a TDC board has been developed for the new high granular time-of-flight neutron detector (HGND). The board is based on the standard LVDS 4x asynchronous oversampling using the xc7k160 FPGA with a 100 ps bin width. The HGND…

We present some aspects of photon counting to study scintillators at low temperatures. A time-to-digital converter (TDC) had been configured to acquire several-minute-long streams of data, simplifying the multiple photon counting…