Related papers: PMT calibration for the JSNS2-II far detector with…
The JSNS$^2$ experiment aims to search for the existence of neutrino oscillations with $\Delta {\rm m}^2$ near 1 eV$^2$ at the J-PARC Materials and Life Science Experimental Facility (MLF). A 3~GeV 1~MW proton beam incident on a mercury…
Procedures and results on hardware level detector calibration in Super-Kamiokande (SK) are presented in this paper. In particular, we report improvements made in our calibration methods for the experimental phase IV in which new readout…
Photomultiplier tubes (PMTs) are widely used in particle experiments for photon detection. PMT waveform analysis is crucial for high-precision measurements of the position and energy of incident particles in liquid scintillator (LS)…
The Jinping Neutrino Experiment (JNE) will utilize approximately 3000 8-inch MCP-PMTs identified as GDB-6082 from North Night Vision Technology to detect neutrinos. To enhance the effective coverage of the JNE detector, mounting a…
The Jiangmen Underground Neutrino Observatory (JUNO) is a 20-kton liquid scintillator-based, low-radioactivity, multi-purpose neutrino detector located 693 meters (1800 m.w.e.) underground in the Guangdong province, China. To detect…
JSNS$^2$ (J-PARC Sterile Neutrino Search at J-PARC Spallation Neutron Source) is an experiment that is searching for sterile neutrinos via the observation of $\bar{\nu}_{\mu} \rightarrow \bar{\nu}_e$ appearance oscillations using neutrinos…
Precise vertex reconstruction is essential for large liquid scintillator detectors. A novel method based on machine learning has been successfully developed to reconstruct the event vertex in JUNO previously. In this paper, the performance…
The 20kt Liquid Scintillator (LS) JUNO detector is being constructed by the International Collaboration in China, with the primary goal of addressing the question of neutrino mass ordering (hierarchy). The main challenge for JUNO is to…
The calibration of the ICARUS photo-detection system is based on a low power laser diode at 405 nm. Laser pulses arrive to one optical switch and then are sent to 36 UHV flanges, by 20 meters long optical patches. Light is then delivered to…
The JUNO experiment requires an excellent energy resolution of 3\% at 1 MeV. To achieve this objective, a total of 20,012 20-inch photomultiplier tubes (PMTs) will be deployed for JUNO, comprising 15,012 multi-channel plate (MCP) PMTs and…
We have investigated the possibility of calibrating the PMTs of scintillation detectors, using the primary scintillation produced by X-rays to induce single photoelectron response of the PMT. The high-energy tail of this response, can be…
The SoLid experiment has been designed to search for an oscillation pattern induced by a light sterile neutrino state, utilising the BR2 reactor of SCK$\bullet$CEN, in Belgium. The detector leverages a new hybrid technology, utilising two…
On May 2008 the ANTARES collaboration completed the installation of a neutrino telescope in the Mediterranean Sea. This detector consists of a tridimensional array of almost 900 photomultipliers (PMTs) distributed in 12 lines. These PMTs…
A description is given of the light-injection calibration system that has been developed for the MINOS long-baseline neutrino oscillation experiment. The system is based upon pulsed blue LEDs monitored by PIN photodiodes. It is designed to…
This paper presents a comprehensive optimisation study to maximise the light collection efficiency of scintillating cube elements used in the SoLid detector. Very short baseline reactor experiments, like SoLid, look for active to sterile…
The Jiangmen Underground Observatory (JUNO) is a 20-kton liquid scintillator detector that employs 20,000 20-inch photomultiplier tubes (PMTs) as photon sensors, with 5,000 dynode-PMTs from HAMAMATSU Photonics K.K. (HPK), and 15,000…
The main goal of the JUNO experiment is the determination of the neutrino mass ordering. To achieve this, an extraordinary energy resolution of at least $3\,\%$ at $1\,$MeV is required for which all parts of the JUNO detector need to meet…
The Jiangmen Underground Neutrino Observatory (JUNO) is a multi-purpose neutrino experiment designed to measure the neutrino mass hierarchy using a central detector (CD), which contains 20 kton liquid scintillator (LS) surrounded by about…
The SoLid collaboration is currently operating a 1.6 tons neutrino detector near the Belgian BR2 reactor, with main goal the observation of the oscillation of electron antineutrinos to previously undetected flavor states. The highly…
The Jiangmen Underground Neutrino Observatory (JUNO) is a multi-purpose neutrino experiment designed to measure the neutrino mass hierarchy using a central detector (CD), which contains 20 kton liquid scintillator (LS) surrounded by about…