Related papers: Design and Implementation of a UDP-Based Command I…
Microwave reflectometry is a non-intrusive plasma diagnostic tool which is widely applied in many fusion devices. In 2014, the microwave reflectometry on Experimental Advanced Superconducting Tokamak (EAST) had been upgraded to measure…
We consider a linear power flow model with interval-bounded nodal power injections and limited line power flows. We determine the minimal number of power injections to control based on a minimal set of measurements, such that the overall…
Today's HPC installations are highly-complex systems, and their complexity will only increase as we move to exascale and beyond. At each layer, from facilities to systems, from runtimes to applications, a wide range of tuning decisions must…
Energy-centric design is paramount in the current embedded computing era: use cases require increasingly high performance at an affordable power budget, often under real-time constraints. Hardware heterogeneity and parallelism help address…
In the modern Systems-on-Chip (SoC), the Advanced eXtensible Interface (AXI) protocol exhibits security vulnerabilities, enabling partial or complete denial-of-service (DoS) through protocol-violation attacks. The recent countermeasures…
The International Large Detector (ILD) at the International Linear Collider (ILC) requires significantly improved subdetector systems to comply with the envisioned performance. Its central tracking detector is a Time Projection Chamber…
This article comprehensively reviews recent developments and research on deep learning-based (DL-based) techniques for integrated sensing and communication (ISAC) systems. ISAC, which combines sensing and communication functionalities, is…
As trapped-ion quantum computing scales to larger qubit registers and more complex control protocols, classical control systems face a fundamental tradeoff: sub-microsecond board-level feedback requires tight hardware coupling, whereas…
In this paper, we design a PXI-based, multi-channel data-acquisition system (DAS) mainly applicable to recording one-shot fast transient pulses in nuclear physics experiments. The system consists of one NI PXIe-1085 chassis, containing a…
While the Experimental Physics and Industrial Control System (EPICS) is widely used at large laboratories for slow controls and instrumentation, the deployment of a full EPICS installation can be difficult, with a steep learning curve to…
The India-based Neutrino Observatory (INO) is an approved multi-institutional experiment of India. It will use maximum 30,000 Resistive Plate Chamber (RPC) of size 2x2m as an active detector in which each will be sandwiched between two iron…
Several types of networks that comprise unmanned aerial vehicles (UAV or drone) are being utilized in important applications such as emergency response, environment and infrastructure monitoring, defense and security, and commerce. In such…
'EPECUR' experiment setup is under construction at the beam line 322 of the ITEP proton synchrotron. The experiment requires several large area drift chambers to provide reasonable acceptance and fine pitch proportional chambers for beam…
Iterative learning control (ILC) is a method for reducing system tracking or estimation errors over multiple iterations by using information from past iterations. The disturbance observer (DOB) is used to estimate and mitigate disturbances…
Modern compute nodes in high-performance computing provide a tremendous level of parallelism and processing power. However, as arithmetic performance has been observed to increase at a faster rate relative to memory and network bandwidths,…
Dynamic spectrum management is recognized as a key technique to tackle interference in multi-user multi-carrier communication systems and networks. However existing dynamic spectrum management algorithms may not be suitable when the…
This talk reports on recent progress concerning the development of a Digital Hadron Calorimeter with Resistive Plate Chambers as active elements. After the successful testing of a Digital Hadron Calorimeter prototype, the DHCAL, in the…
This paper introduces a novel framework aimed at designing integrated waveforms for robust integrated sensing and communication (ISAC) systems. The system model consists of a multiple-input multiple-output (MIMO) base station that…
A stability chamber is essential for pharmaceutical facilities to test the stability and quality of products over time by exposing them to different environmental conditions. This paper introduces an IoT-enabled stability chamber designed…
High-performance computing (HPC) requires resilience techniques such as checkpointing in order to tolerate failures in supercomputers. As the number of nodes and memory in supercomputers keeps on increasing, the size of checkpoint data also…