Related papers: Beamforming with Oversampled Time-Modulated Arrays
Time-modulated arrays (TMAs) are able to improve the side-lobe level of the radiation pattern at the fundamental mode but cannot steer the beam at such a mode towards a given direction. Beam-steering is possible in a TMA, but only at the…
Time-modulated arrays (TMAs) can effectively perform beamsteering over the first positive harmonic pattern by applying progressively delayed versions of stair-step approximations of a sine waveform to the antenna excitations. In this…
The time-modulated array is a simple array architecture in which each antenna is connected to an RF switch that serves as a modulator. The phase shift is achieved by digitally controlling the relative delay between the periodic modulating…
Bipolar (+/-1) sequences with no zero state suit particularly well for safeguarding the switched feeding network efficiency when applied to time-modulated arrays (TMAs). During the zero state of a conventional time-modulating sequence, if a…
High-frequency wideband cellular communications over mmWave and sub-THz offer the opportunity for high data rates. However, it also presents high path loss, resulting in limited coverage. High-gain beamforming from the antenna array is…
A frequency-diverse array (FDA) is an alternative array architecture in which each antenna is preceded by a mixer instead of a phase shifter. The mixers introduce a frequency offset between signals transmitted by each antenna, resulting in…
Beamforming makes possible a focused communication method. It is extensively employed in many disciplines involving electromagnetic waves, including arrayed ultrasonic, optical, and high-speed wireless communication. Conventional beam…
We present an innovative approach that simultaneously enables direct antenna frequency-hopped M-ary frequency shift keying (DAFH-MFSK) modulation and beamsteering through the use of time-modulated arrays (TMAs). The distinctive feature of…
In this correspondence, we propose a movable antenna (MA)-aided multi-user hybrid beamforming scheme with a sub-connected structure, where multiple movable sub-arrays can independently change their positions within different local regions.…
Two beam broadening methods for active electronically scanned array (AESA) antennas with uniform amplitude excitation are proposed and compared: phase tapering optimization (PTO) and a novel time-varying phase tapering (TPT). The PTO is a…
The utilization of millimeter wave frequency bands is expected to become prevalent in the following communication systems. However, generating and transmitting communication signals over these frequencies is not as straightforward as in…
Hybrid beamforming is an attractive solution to build cost-effective and energy-efficient transceivers for millimeter-wave and terahertz systems. However, conventional hybrid beamforming techniques rely on analog components that generate a…
Dynamic metasurface antennas (DMA) provide low-power beamforming through reconfigurable radiative slots. Each slot has a tunable component that consumes low power compared to typical analog components like phase shifters. This makes DMAs a…
This paper proposes a bidirectional multibeam hybrid transmitarray (HTA) employing a transmission polarization-rotating metasurface (TPRM). A novel configuration is introduced to facilitate bidirectional beam scanning by combining the…
This article presents an overview and analysis of spatial-to-spectral harmonic-modulated arrays (SHAs). Compared to traditional analog or digital beamforming arrays, SHAs enable concurrent multi-beamforming without requiring substantial…
In the recent papers [1-4] including above paper time modulated frequency diverse arrays (FDAs) have been presented to obtain time invariant spatial patterns. The presented FDAs in [1-3] have the feature of time-invariant spatial focusing…
Broadband beamforming is a technique to obtain the signal with a wide range of frequencies. It maintains the signal integrity and spatial selectivity over frequencies. This is important in several applications such as microphone array,…
In order to cope with the large path-loss exponent of mm-Wave channels, a high beamforming gain is needed. This can be achieved with small hardware complexity and high hardware power efficiency by Hybrid Digital-Analog (HDA) beamforming,…
In most multiple-input multiple-output (MIMO) communication systems, e.g., Massive MIMO, the antenna spacing is generally no less than half a wavelength. It helps to reduce the mutual coupling and therefore facilitate the system design. The…
Recently, movable antenna (MA) array becomes a promising technology for improving the communication quality in wireless communication systems. In this letter, an unmanned aerial vehicle (UAV) enabled multi-user multi-input-single-output…