Related papers: REBCO delamination characterization by 90 degree p…
The implementation of the 2nd generation high-Tc superconductors in power applications, such as electrical transformers, motors and generators requires superconducting wires that are superior to copper Litz wires at cryogenic temperatures…
The transverse magnetoresistance of thin films of the Diluted Magnetic Semiconductor Zn$_{1-x}$Co$_{x}$O:Al on glass was studied for temperatures in the range of 5 to 100 K. Measurements were made on thin films grown by rf magnetron…
We observe an unusual behavior of the spin Hall magnetoresistance (SMR) measured in a Pt ultra-thin film deposited on a ferromagnetic insulator, which is a tensile-strained LaCoO3 (LCO) thin film with the Curie temperature Tc=85K. The SMR…
The electrical resistivity rho_c of the underdoped cuprate superconductor YBCO was measured perpendicular to the CuO_2 planes on ultra-high quality single crystals in magnetic fields large enough to suppress superconductivity. The…
We use magneto-conductivity to study the magnetic proximity effect on surface states of doped topological insulators. Our bilayers consist of a layer of Fe$_7$Se$_8$, which is a metallic ferrimagnet and a layer of…
We report here that magnetic fields of almost 34 T, far above the upper 24 T limit of Nb3Sn, can be generated using a multifilament round wire conductor made of the high temperature cuprate superconductor Bi2Sr2CaCu2O8-x (Bi-2212). A…
An instrument has been constructed to measure a large range of magnetostriction and thermal expansion between room temperature and 4 K in a superconductive split-coil magnet, that allows investigation in magnetic fields up to 12 T. The very…
Several issues concerning the applicability of the temperature coefficient of the resistivity (TCR) method to scaled interconnect lines are discussed. The central approximation of the TCR method, the substitution of the interconnect wire…
There is evidence that magnetism can potentially increase the thermopower of materials, most likely due to magnon scattering, suggesting the incorporation of intrinsic magnetic semiconductors in non-magnetic thermoelectric materials. Here,…
With the aim of understanding failure modes in the peeling of silicone-based adhesive joints and, in particular, the occurrence of adhesive or cohesive failure, an experimental campaign has been conducted by considering plastic substrates…
Future hard (10 -100 keV) X-ray telescopes (SIMBOL-X, Con-X, HEXIT-SAT, XEUS) will implement focusing optics with multilayer coatings: in view of the production of these optics we are exploring several deposition techniques for the…
REBCO high-temperature superconductors are promising for fully superconducting high-field magnets, including ultra-high field magnets. Non-insulated (NI) and metal-insulated (MI) windings are a good solution for protection against…
We present a concept of the rapid-cycling 1.7 T ReBCO magnet for 1 to 10 kT/s ramping range as required for muon acceleration in a future muon collider presently under study. This approach is based on the 6 kA CORC-like cable constructed…
We propose a new type of high temperature superconducting (HTS) conductor concept: modularized conductors (MC) connected by Chinese traditional tenon mortise (TM) connection structure, reffered as TMMC. The conductor consists of multiple…
Superconducting high field magnets have the capability to generate over 40 T, with multiple existing practical applications globally. However, at such high magnetic fields, these magnets are prone to rapid electrothermal quench which can…
Doping is one of the most relevant paths to tune the functionality of cuprates, it determines carrier density and the overall physical properties of these impressive superconducting materials. We present an oxygen doping study of…
We grew single crystals of U6Co by the self-flux method and measured the magnetic susceptibility, resistivity, and specific heat. The magnetic susceptibility shows very small anisotropy and weak temperature dependence, indicating small…
Future collider detectors, including silicon tracking detectors planned for the High Luminosity LHC, will require components and mechanical structures providing unprecedented strength-to-mass ratios, thermal conductivity, and radiation…
The irreversible magnetization of the layered high-T_{c} superconductor Bi_{2+x}Sr_{2-(x+y)}Cu_{1+y}O_{6 +- delta} (Bi-2201) has been measured by means of a capacitive torquemeter up to B=28 T and down to T=60 mK. No magnetization jumps,…
Many superconducting power applications contain REBCO coils. Superconducting motors are very interesting for mobile applications like aviation, thanks to their high power per unit weight. In order to reduce the inductance, multi-tape…