Related papers: Sensitivity adjustable in-line high-temperature se…
Three different types of Er doped photosensitive fibers, germanium/erbium (Ge/Er) fiber, tin/germanium/erbium fiber (Sn/Er) and antimony/germanium/erbium fiber (Sb/Er) have been manufactured and studied for use in optical sensor systems.…
Perturbations to the effective refractive index from nanometer-scale fabrication variations in waveguide geometry plague high index-contrast photonic platforms including the ubiquitous sub-micron silicon-on-insulator (SOI) process. Such…
We demonstrate an inertia sensitive atom interferometer optically guided inside a 22-cm-long negative curvature hollow-core photonic crystal fiber with an interferometer time of 20 ms. The result prolongs the previous fiber guided atom…
A fully on-fiber optomechanical cavity is fabricated by patterning a suspended metallic mirror on the tip of an optical fiber. Optically induced self-excited oscillations of the suspended mirror are experimentally demonstrated. We discuss…
The use of relatively simple structures to achieve high performance refractive index sensors has always been urgently needed. In this work, we propose a lithography-free sensing platform based on metal-dielectric cavity, the sensitivity of…
A fundamental limit to the sensitivity of optical interferometry is thermal noise that drives fluctuations in the positions of the surfaces of the interferometer's mirrors, and thereby in the phase of the intracavity field. Schemes for…
Superconducting radio-frequency (SRF) thin film cavities on copper substrates are employed in several particle accelerators. However, these SRF cavities historically featured a progressive performance degradation with the accelerating field…
Simultaneous laser locking of IR and UV lasers to a visible stabilized reference laser is demonstrated via a Fabry-Perot cavity. LabVIEW is used to analyze the input and an internal PID algorithm converts the Fabry-Perot signal to an analog…
Cryogenic temperatures are the prerequisite for many advanced scientific applications and technologies. The accurate determination of temperature in this range and at the submicrometer scale is, however, nontrivial. This is due to the fact…
The optical Vernier effect magnifies the sensing capabilities of an interferometer, allowing for unprecedented sensitivities and resolutions to be achieved. Just like a caliper uses two different scales to achieve higher resolution…
Here, we present the thermal tuning capability of an alignment-free fiber-integrated Fabry-P\'erot cavity.The two mirrors are made of fiber Bragg gratings that can be individually temperature stabilized and tuned. We show the temperature…
We experimentally demonstrate the high-sensitivity optical monitoring of a micro-mechanical resonator and its cooling by active control. Coating a low-loss mirror upon the resonator, we have built an optomechanical sensor based on a very…
We present a novel method of machining optical fiber surfaces with a CO${}_2$ laser for use in Fiber-based Fabry-Perot Cavities (FFPCs). Previously FFPCs were prone to large birefringence and limited to relatively short cavity lengths…
This paper presents a fully-integrated CMOS temperature sensor for densely-distributed thermal monitoring in systems on chip supporting dynamic voltage and frequency scaling. The sensor front-end exploits a sub-threshold PMOS-based circuit…
Cavity optomechanical magnetic field sensors, constructed by coupling a magnetostrictive material to a micro-toroidal optical cavity, act as ultra-sensitive room temperature magnetometers with tens of micrometre size and broad bandwidth,…
We demonstrate a fiber Fabry-Perot (FFP) sensor capable of detecting sub-picostrain signals, from 100 Hz and extending beyond 100 kHz, using the Pound-Drever-Hall frequency locking technique. A low power diode laser at 1550 nm is locked to…
An optical etalon illuminated by a white light source provides a broadband comb-like spectrum that can be employed as a calibration source for astronomical spectrographs in radial velocity (RV) surveys for extrasolar planets. For this…
We have recently developed a narrow band imager (NBI) using an air gap based Fabry-P\'erot (FP) interferometer at the Indian Institute of Astrophysics, Bangalore. Narrow band imaging is achieved by using an FP interferometer working in…
We describe a compact calorimeter that opens ultra-low temperature heat capacity studies of small metal crystals in moderate magnetic fields. The performance is demonstrated on the canonical heavy Fermion metal YbRh2Si2. Thermometry is…
We propose a high thermal conductivity infrared (IR) filter using alumina for use in millimeter wave detection systems. We constructed a prototype two-layer anti-reflection (AR) coated alumina filter with a diameter of 100mm and a thickness…