Related papers: Characterization and optimization of high-efficien…
The rigorous coupled-wave approach (RCWA) and the differential evolution algorithm (DEA) were coupled in a practicable approach to maximize absorption in optical structures with three-dimensional morphology. As a model problem, optimal…
Absorbed sunlight in a solar cell produces electrons and holes. But, at the open circuit condition, the carriers have no place to go. They build up in density and, ideally, they emit external fluorescence that exactly balances the incoming…
CdTe-based thin film solar cell has been modeled and enumerated with a thin CuInTe2 (CIT) current booster layer. CdTe-based n-CdS/p-CdTe/p+-CIT/p++-WSe2 heterojunction device has been evaluated for the highest performance. It is revealed…
This paper proposes an efficient three-layered p-GaAs/p-CIGS/n-CdS (PPN), a unique solar cell architecture. Copper indium gallium selenide (CIGS)-based solar cells exhibit substantial performance than the ones utilizing cadmium sulfide…
In this work, first principle calculations of Cu$_2$ZnSnS$_4$ (CZTS), Cu$_2$ZnGeS$_4$ (CZGS) and Cu$_2$ZnSiS$_4$ (CZSS) are performed to highlight the impact of the cationic substitution on the structural, electronic and optical properties…
Photoelectrochemical (PEC) water splitting to generate hydrogen is one of the most studied methods for converting solar energy into clean fuel because of its simplicity and potentially low cost. Despite over 40 years of intensive research,…
Kesterite is a leading candidate among inorganic thin-film photovoltaic technologies, offering sustainable and environmentally friendly solutions without reliance on critical raw materials. This study investigates the performance of…
Solution-processed amorphous silicon is a promising material for semiconductor devices. Unfortunately, its manufacturing leaves a high density of defects in the layer, which can be reduced by a treatment with hydrogen radicals. Here, we…
Electron beam induced current (EBIC) is a powerful characterization technique which offers the high spatial resolution needed to study polycrystalline solar cells. Ideally, an EBIC measurement reflects the spatially resolved quantum…
Excitonic semiconductors have been a subject of research for photovoltaic applications for many decades. Among them, the organic polymers and small molecules based solar cells have now exceeded 19% power conversion efficiency (PCE). While…
Silicon solar cells dominate the solar cell market with record lab efficiencies reaching almost 26%. However, after 60 years of research, this efficiency saturated close to the theoretical limit for silicon, and radically new approaches are…
Luminescent solar concentrators (LSCs) are able to concentrate both direct and diffuse solar radiation and this ability has led to great interest in using them to improve solar energy capture when coupled to traditional photovoltaics (PV).…
We obtain theoretical expressions for the photocurrent in the Heterojunction solar cells with Intrinsic Thin layer (HIT cells). Our calculations take into account tunneling of electrons and holes through wide-bandgap layers of $\alpha$-Si:H…
The current state of the art in direct water splitting in photo-electrochemical cells (PECs) is presented together with: (i) a case study of water splitting using a simple solar cell with the most efficient water splitting electrodes and…
Maximum efficiency of ideal single-junction photovoltaic (PV) cells is limited to 33% (for one sun illumination) by intrinsic losses such as band edge thermalization, radiative recombination, and inability to absorb below-bandgap photons.…
The results of our researches of the influence of exponentially distributed surface centers on the effective surface recombination rate and the parameters of silicon solar cells (SCs) are reported. In our calculations, we assumed the…
We propose a two-stage multi-objective optimization framework for full scheme solar cell structure design and characterization, cost minimization and quantum efficiency maximization. We evaluated structures of 15 different cell designs…
In this work, novel, high-throughput metrology methods are used to perform a detailed performance loss analysis of approximately 400 industrial crystalline silicon solar cells, all coming from the same production line. The characterization…
Chalcopyrite semiconductors are of considerable interest for application as absorber layers in thin-film photovoltaic cells. When growing films of these compounds, however, they are often found to contain CuAu- like domains, a metastable…
Deposition of perovskite thin films by antisolvent engineering is one of the most common methods employed in perovskite photovoltaics research. Herein, we report on a general method that allows the fabrication of highly efficient perovskite…