Related papers: A 97% Peak Efficiency Single-Inductor-Multiple-Out…
Basic SiC bipolar transistors have been studied in the past for their applications where high power or high temperature operation is required. However since the current gain in SiC bipolar transistors is very low and therefore, a large base…
Digital Computing-in-Memory (DCIM) is an innovative technology that integrates multiply-accumulation (MAC) logic directly into memory arrays to enhance the performance of modern AI computing. However, the need for customized memory cells…
Impedance models are widely used in assessing small signal stability of grid-tied voltage source converter (VSC) systems. Recent research has proven that impedance models of grid-tied VSC in both dq and sequence domains are generally…
We present an evaluation of a novel on-chip charge detector, called the Single electron Sensitive Read Out (SiSeRO), for charge-coupled device (CCD) image sensor applications. It uses a p-MOSFET transistor at the output stage with a…
This paper discusses a 100 W single stage Power Factor Correction (PFC) flyback converter operating in boundary mode constant ON time methodology using a synchronous MOS-FET rectifier on the secondary side to achieve higher efficiency.…
While Single Molecule Transistors have been employed in laboratory research for a number of years, there remain many details related to charge transport that have yet to be delineated. We have used the technique of electromigration to…
Motivated by the demand for energy-efficient communication solutions in the next generation cellular network, a mixed-ADC receiver architecture for massive multiple input multiple output (MIMO) systems is proposed, which differs from…
We demonstrate the fabrication of a single electron transistor device based on a single ultra-small silicon quantum dot connected to a gold break junction with a nanometer scale separation. The gold break junction is created through a…
The device concept of ferroelectric-based negative capacitance (NC) transistors offers a promising route for achieving energy-efficient logic applications that can outperform the conventional semiconductor technology, while viable operation…
The feasible set of real powers that can be transferred by a three-terminal Soft Open Point (SOP) can be increased by selecting non-uniform power ratings for each of the three ac/dc legs of the SOP, then connecting a multi-terminal switch…
The grid-forming converter is an important unit in the future power system with more inverter-interfaced generators. However, improving its performance is still a key challenge. This paper proposes a generalized architecture of the…
Cuk and SEPIC are some of the important DC-DC converters used for charging batteries. In this paper, a generalized circuit averaging technique is employed for Cuk and SEPIC converters. The derived equations are used to obtain the frequency…
In order to achieve the driver function for several types of scientific CCD detector from E2V Co Ltd, and decreasing the size of electronics of CCD detector system, an Application-specified Integrated Circuit (ASIC) was designed. It…
The power consumption of high-speed, high-resolution analog to digital converters (ADCs) is a limiting factor in implementing large-bandwidth mm-wave communication systems. A mitigating solution, which has drawn considerable recent…
Advances in power electronics have made it possible to achieve high power levels, e.g., reaching GW in grids, or alternatively high output bandwidths, e.g., beyond MHz in communication. Achieving both simultaneously, however, remains…
This paper presents a hybrid switched-capacitor converter (HSCC) with a novel multi-mode modulation (3M) scheme for wide-range voltage regulation in 48-V automotive power systems. By introducing a three-state operating sequence beyond the…
Voltage conversion is a fundamental electronic process critical to engineered systems across a wide spectrum of applications and spanning many orders of magnitude in scale. Conventional approaches like transformers and charge pumps perform…
Single electron Sensitive Read Out (SiSeRO) is a novel on-chip charge detector output stage for charge-coupled device (CCD) image sensors. Developed at MIT Lincoln Laboratory, this technology uses a p-MOSFET transistor with a depleted…
In this article, we propose a nonlinear voltage control to ensure power exchange in a multiport interconnected system, which consists of a bidirectional DC-DC converter and generating-storing devices. The converter topology under…
Artificial-intelligence (AI) workloads are driving rapid growth in data-center electricity use and rack power density, increasing demand for power-delivery systems that are efficient and robust to fast load transients. Conventional…