Related papers: Full-Duplex Multiuser MISO Under Coarse Quantizati…
In this paper we study the spectral efficiency (SE) of a point-to-point massive multiple-input multiple-output system (P2P-massive MIMO) with limited radio frequency (RF) chains, i.e., analog-to-digital/ digital-to-analog (D2A/A2D) modules,…
In this paper, we study the physical layer multicasting to multiple co-channel groups in large-scale antenna systems. The users within each group are interested in a common message and different groups have distinct messages. In particular,…
This paper investigates a six-dimensional movable antenna (6DMA)-aided cell-free multi-user multiple-input multiple-output (MIMO) communication system. In this system, each distributed access point (AP) can flexibly adjust its array…
Two-channel modulo analog-to-digital converters (ADCs) enable high-dynamic-range signal sensing at the Nyquist rate per channel, but existing designs quantise both channel outputs independently, incurring redundant bitrate costs. This paper…
This study employs a uniform rectangular array (URA) sub-connected hybrid beamforming (SC-HBF) architecture to provide a novel self-interference (SI) suppression scheme in a full-duplex (FD) massive multiple-input multiple-output (mMIMO)…
Hybrid beamforming (HBF) and antenna selection are promising techniques for improving the energy efficiency~(EE) of massive multiple-input multiple-output~(mMIMO) systems. However, the transmitter architecture may contain several parameters…
We consider a full-duplex (FD) decode-and-forward system in which the time-switching protocol is employed by the multi-antenna relay to receive energy from the source and transmit information to the destination. The instantaneous throughput…
In order to reduce hardware complexity and power consumption, massive multiple-input multiple-output (MIMO) systems employ low-resolution analog-to-digital converters (ADCs) to acquire quantized measurements $\boldsymbol y$. This poses new…
We consider high-dimensional MIMO transmissions in frequency division duplexing (FDD) systems. For precoding, the frequency selective channel has to be measured, quantized and fed back to the base station by the users. When the number of…
The joint design of analog beamforming and power allocation is investigated for a single radio-frequency chain multiuser time-division multiple access system under a max-min signal-to-noise ratio (SNR) criterion. A hardware-efficient…
Future cellular systems based on the use of millimeter waves will heavily rely on the use of antenna arrays both at the transmitter and at the receiver. For complexity reasons and energy consumption issues, fully digital precoding and…
In this paper, we propose and evaluate a novel beamforming strategy for directional frame timing synchronization in wideband millimeter-wave (mmWave) systems operating with low-resolution analog-to-digital converters (ADCs). In the employed…
This paper considers the design of the beamformers for a multiple-input single-output (MISO) downlink system that seeks to mitigate the impact of the imperfections in the channel state information (CSI) that is available at the base station…
This paper focuses on channel estimation in single-user and multi-user MIMO systems with multi-antenna base stations equipped with 1-bit spatial sigma-delta analog-to-digital converters (ADCs). A careful selection of the quantization…
We consider a wideband integrated access and backhaul system operating in full-duplex mode between the New Radio gNB donor and single user equipment. Due to high power consumption in millimeter wave systems, we use low-resolution…
In this paper we aim to solve the multiuser multi-input multi-output (MIMO) downlink beamforming problem where one multi-antenna base station broadcasts data to many users. Each user is assigned multiple data streams and has multiple…
This paper studies fast downlink beamforming algorithms using deep learning in multiuser multiple-input-single-output systems where each transmit antenna at the base station has its own power constraint. We focus on the…
Cell-free massive MIMO has matured into a key candidate technology for 6G and beyond, owing to its ability to provide nearly uniform service quality to many user equipments (UEs) over the same time-frequency resources. Unlike conventional…
In this paper, multi-stream transmission in interference networks aided by multiple amplify-and-forward (AF) relays in the presence of direct links is considered. The objective is to minimize the sum power of transmitters and relays by…
In massive MIMO systems, hybrid beamforming is an essential technique for exploiting the potential array gain without using a dedicated RF chain for each antenna. In this work, we consider the data phase in a massive MIMO communication…