Related papers: Thermal noise calibration of functionalized cantil…
The deflection signal of a thermally excited force sensor of an atomic force microscope can be analyzed to gain important information about the detector noise and about the validity of the equipartion theorem of thermodynamics. Here, we…
Insulated cantilever probes with a high aspect ratio conducting apex have been fabricated and their dynamic and electrical properties analyzed. The cantilevers were coated with silicon dioxide and a via was fabricated through the oxide at…
Commercial atomic force microscopes usually use a four-segmented photodiode to detect the motion of the cantilever via laser beam deflection. This read-out technique enables to measure bending and torsion of the cantilever separately. A…
Thermoelectric power sensors used as power transfer standards are promising devices for further enhancements of the microcalorimetric technique in the high frequency field. A coaxial microcalorimeter has been studied, based on…
We discuss a proposal to measure the Casimir force in the parallel plate configuration in the $1-10\mu$m range via a high-sensitivity torsional balance. This will allow to measure the thermal contribution to the Casimir force therefore…
Low-noise cryogenic microwave amplifiers are widely used in applications such as radio astronomy and quantum computing. On-wafer noise characterization of cryogenic low-noise transistors is desirable because it facilitates more rapid…
Monoenergetic photons from a pulsed laser diode or LED are commonly used to calibrate the detector response of high-resolution calorimetric detectors. However, when the detector's resolution is larger than the energy of a single photon, a…
We provide a detailed description of a general procedure by which a nano/micro-mechanical resonator can be calibrated using its thermal motion. A brief introduction to the equations of motion for such a resonator is presented, followed by a…
Frequency dependent dynamic behavior in Piezoresponse Force Microscopy (PFM) implemented on a beam-deflection atomic force microscope (AFM) is analyzed using a combination of modeling and experimental measurements. The PFM signal comprises…
We present a simple analysis of the force noise associated with the mechanical damping of the motion of a test body surrounded by a large volume of rarefied gas. The calculation is performed considering the momentum imparted by inelastic…
The recent discovery that silicon nitride membranes can be used as extremely high Q mechanical resonators makes possible a number of novel experiments, which include improved long range vacuum Casimir force measurements, and measurments of…
We consider an optical probe that interacts with an ensemble of rare earth ions doping a materialin the shape of a cantilever. By optical spectral hole burning, the inhomogeneously broadenedtransition in the ions is prepared to transmit the…
Probes that measure the local thermal properties of systems out of equilibrium are emerging as new tools in the study of nanoscale systems. One can then measure the temperature of a probe that is weakly coupled to a bias-driven system. By…
Magnetic Resonance Force Microscopy (MRFM) is a powerful technique to detect a small number of spins that relies on force-detection by an ultrasoft magnetically tipped cantilever and selective magnetic resonance manipulation of the spins.…
Quantum measurement is physically realized through a finite dynamical interaction between a system and a measuring apparatus, giving rise to a continuous transition from weak to strong regimes. While this crossover is well understood under…
We measure interaction forces between pairs of charged PMMA colloidal particles suspended in a relatively low-polar medium (5 $\lesssim \epsilon \lesssim$ 8) directly from the deviations of particle positions inside two time-shared optical…
The dynamic behavior of AFM is studied taking into account the nonlinear interaction forces between probe and sample. The exerted forces on the free end of micro-beam are simulated with the third degree polynomial. The effect of some…
We demonstrate temperature measurement of a sample attached to the end of a cantilever using cantilever magnetometry of solid air ``contamination'' of the sample surface. In experiments like our Magnetic Resonance Force Microscopy (MRFM),…
The ultimate sensitivities achieved in force or mass sensing are limited by the employed nanomechanical probes thermal noise. Its proper understanding is critical for ultimate operation and any deviation from the underlying fluctuation…
Increasing requirements in the sensitivity of interferometric measurements is a common feature of several research fields, from gravitational wave detection to quantum optics. This motivates refined studies of high reflectivity mirrors and…