Related papers: Effect of streaks on hypersonic boundary layer ins…
A high-fidelity simulation of the shock/transitional boundary layer interaction caused by a 15-degrees axisymmetrical compression ramp is performed at a freestream Mach number of 5 and a transitional Reynolds number. The inlet of the…
It has often been proposed that the formation of large-scale motion (or bulges) is a consequence of successive mergers and/or growth of near-wall hairpin vortices. In the present study, we report our direct observation that large-scale…
Large eddy simulations and three-dimensional proper orthogonal decomposition were used to study the interaction between a large stationary and moving bluff body and a high Reynolds number stably-stratified turbulent boundary layer. An…
The interaction between an incident shock wave and a Mach-6 undisturbed hypersonic laminar boundary layer over a cold wall is addressed using direct numerical simulations (DNS) and wall-modeled large-eddy simulations (WMLES) at different…
Large-eddy simulations of a flat-plate boundary layer, without a leading edge, subject to multiple levels of incoming free stream turbulence are considered in the present work. Within an input-output model where non-linear terms of the…
Mixing and heat transfer rates are typically enhanced when operating at high-pressure transcritical turbulent flow regimes. The rapid variation of thermophysical properties in the vicinity of the pseudo-boiling region can be leveraged to…
Laminar-turbulent transition in shock wave-boundary-layer interactions (SWBLI) remains a major challenge for hypersonic vehicle design, with implications for drag, heat transfer, and structural loads. Linear optimal perturbation analyses…
We extend linear input/output (resolvent) analysis to take into account nonlinear triadic interactions by considering a finite number of harmonics in the frequency domain using the harmonic balance method. Forcing mechanisms that maximize…
The shock-boundary layer interaction over the convex wall of a supersonic turbine vane is studied with a focus on extreme separation bubble events and the interplay between the bubble, streaks, and streamwise vortices. The present analysis…
A combination of methods originating from non-stationary timeseries analysis is applied to two datasets of near surface turbulence in order to gain insights on the non-stationary enhancement mechanism of intermittent turbulence in the…
Non-stationarity is the rule in the atmospheric boundary layer (ABL). Under such conditions, the flow may experience departures from equilibrium with the underlying surface stress, misalignment of shear stresses and strain rates, and…
The formation and amplification of streamwise velocity perturbations induced by cross-stream disturbances is ubiquitous in shear flows. This disturbance growth mechanism, so neatly identified by Ellingsen and Palm in 1975, is a key process…
A flat-plate laminar boundary layer is simulated at Mach 6 and unit Reynolds number of 1.1e7 using the Direct Simulation Monte Carlo (DSMC) method to capture and analyze spontaneous second-mode instability growth. Power spectral density…
In many plasma systems, introducing a small background shear flow is enough to stabilize the system linearly. The nonlinear dynamics are much less sensitive to sheared flows than the average linear growthrates, and very small amplitude…
We analyze the role of the relative phasing in the nonlinear saturation of the unstable Mack modes in a hypersonic parallel flow boundary layer in two dimensions (2D). As the linearly unstable Mack modes extract energy from the mean flow,…
In this study,we investigate the characteristics of three-dimensional turbulent boundary layers influenced by transverse flow and pressure gradients. Our findings reveal that even without assuming an infinite sweep, a fully developed…
Several simulations of turbulence in the Large Plasma Device (LAPD) [W. Gekelman et al., Rev. Sci. Inst. 62, 2875 (1991)] are energetically analyzed and compared with each other and with the experiment. The simulations use the same model,…
Hydraulic jumps are oftentimes encountered in natural and human-made environments. The transition from supercritical to subcritical flow involves large energy dissipation rates and substantial air entrainment, preventing the use of…
Turbulence modeling has the potential to revolutionize high-speed vehicle design by serving as a co-equal partner to costly and challenging ground and flight testing. However, the fundamental assumptions that make turbulence modeling such…
The streamwise roll and streak structure (RSS) is prominent in observations of the planetary boundary layer in the atmosphere and ocean and in unstratified wall-bounded shear flows. Although the RSS in these systems is structurally similar,…