Related papers: Arm-Locking Frequency Noise Suppression for Astron…
Space-based interferometric gravitational wave instruments such as the ESA/NASA Laser Interferometer Space Antenna (LISA) observe gravitational waves by measuring changes in the light travel time between widely-separated spacecraft. One…
Probing extra polarizations in gravitational waves (GWs) with space-based detectors is the most direct method for testing theories of gravity. In this paper, by employing the second-generation time-delay interferometry (TDI) to cancel out…
The volume of radio-astronomical data is a considerable burden in the processing and storing of radio observations with high time and frequency resolutions and large bandwidths. Lossy compression of interferometric radio-astronomical data…
Time-delay interferometry (TDI) is essential for space-based gravitational wave (GW) missions to effectively suppress laser frequency noise and achieve targeting sensitivity. The principle of the TDI is to synthesize multiple laser link…
Atom Interferometric Gravitational-wave (GW) Space Observatory (AIGSO) is a mission concept mainly aimed at the middle-frequency (0.1 Hz - 10 Hz) GW detection. AIGSO proposes to have three spacecraft in linear formation with extension of 10…
We propose a new method to reduce the frequency noise of a Local Oscillator (LO) to the level of white phase noise by maintaining (not destroying by projective measurement) the coherence of the ensemble pseudo-spin of atoms over many…
We make the case for the early development of a Mid-Frequency-Band (MFB) gravitational wave (GW) observatory in geosynchronous orbit (73,000 km arm), optimized for the frequency band 10 mHz to 1 Hz. MFB bridges the science acquisition…
A recent proposal describes space based gravitational wave (GW) detection with optical lattice atomic clocks [Kolkowitz et. al., Phys. Rev. D 94, 124043 (2016)] [1]. Based on their setup, we propose a new measurement method for…
We present a method to characterize the noise in ground-based gravitational-wave observatories such as the Laser Gravitational-Wave Observatory (LIGO). This method uses linear regression algorithms such as the least absolute shrinkage and…
Interferometric gravitational wave antennas are based on Michelson interferometers whose sensitivity to small differential length changes has been enhanced by adding multiple coupled optical resonators. The use of optical cavities is…
Interferometric gravitational wave detectors are expected to be limited by shot noise at some frequencies. We experimentally demonstrate that a power recycled Michelson with squeezed light injected into the dark port can overcome this…
TianQin is a proposed geocentric space-based gravitational wave observatory mission, which requires time-delay interferometry (TDI) to cancel laser frequency noise. With high demands for precision, solar-wind plasma environment at $\sim…
We have demonstrated broadband frequency-noise suppression in a laser stabilization system by augmenting a conventional proportional-integral-derivative (PID) controller with a digital disturbance observer (DOB) implemented on a…
Laser frequency noise (LFN) is the dominant source of noise expected in the Laser Interferometer Space Antenna (LISA) mission, at $\sim$7 orders of magnitude greater than the typical signal expected from gravitational waves (GWs).…
The proposed space-borne laser interferometric gravitational wave (GW) observatory TianQin adopts a geocentric orbit for its nearly equilateral triangular constellation formed by three identical drag-free satellites. The geocentric distance…
The range to which the Laser Interferometer Gravitational-Wave Observatory (LIGO) can observe astrophysical systems varies over time, limited by noise in the instruments and their environments. Identifying and removing the sources of noise…
Squeezed vacuum states are now employed in gravitational-wave interferometric detectors, enhancing their sensitivity and thus enabling richer astrophysical observations. In future observing runs, the detectors will incorporate a filter…
We show that back-action noise in interferometric measurements such as gravitational-waves detectors can be completely suppressed by a local control of mirrors motion. An optomechanical sensor with an optimized measurement strategy is used…
The accurate sky localization of gravitational wave (GW) sources is an important scientific goal for space-based GW detectors. The main differences between future space-based GW detectors, such as Laser Interferometer Space Antenna (LISA),…
The detectors of the laser interferometer gravitational-wave observatory (LIGO) are broadly limited by the quantum noise and rely on the injection of squeezed states of light to achieve their full sensitivity. Squeezing improvement is…