Related papers: Optical signatures of defects in BiFeO$_3$
The pressure dependence of light-induced effects in single-crystalline BiFeO$_3$ is studied by optical spectroscopy. At low pressures, we observe three light-induced absorption features with energies just below the two crystal field…
In electrically polar solids optomechanical effects result from the combination of two main processes, electric field-induced strain and photon-induced voltages. Whereas the former depends on the electrostrictive ability of the sample to…
The dielectric function of heteroepitaxial YBiO$_3$ grown on $a$-Al$_2$O$_3$ single crystals via pulsed laser deposition is determined in the spectral range from 0.03 eV to 4.5 eV by simultaneous modeling of spectroscopic ellipsometry and…
The substitution of bismuth by samarium in BiFeO3 is known to induce a structural phase transition from the polar phase to a non-polar phase, with a possible antiferroelectric intermediate structure. In this paper, we investigate the impact…
BiFeO$_3$ is a technologically relevant multiferroic perovskite featuring ferroelectricity and antiferromagnetism. Its lattice, magnetic, and ferroelectric degrees of freedoms are coupled to its optically active excitations and thus hold…
A first-principles study on the quasiparticles energy and optical absorption spectrum of fluorographene is presented by employing the GW + Bethe-Salpeter Equation (BSE) method with many-electron effects included. The calculated band gap is…
The relationship between the luminescence at 1.9 eV and the absorption bands at 2.0 eV and at 4.8 eV were investigated in a wide variety of synthetic silica samples exposed to different gamma- and beta-ray irradiation doses. We found that…
We report on optical studies of the thin films of multiferroic hexagonal (P.G. 6mm) rare-earth orthoferrites RFeO3 (R=Ho, Er, Lu) grown epitaxially on a (111)-surface of ZrO2(Y2O3) substrate. The optical absorption study in the range of…
One of the basic optoelectronic characteristics is the absorption of any optoelectronic device or material. We present the characteristics of pure GaAs and the deviation of ideal spectra. Due to crystal defects, vacancies, impurities, etc.,…
Nickel oxide is a versatile p-type semiconducting oxide with many applications in opto-electronic devices, but high doping concentrations are often required to achieve necessary electrical conductivity. In contrast to many other transparent…
We provide a combined theoretical and experimental study of the electronic structure and the optical absorption edge of the orthorhombic perovskite LaInO$_{3}$. Employing density-functional theory and many-body perturbation theory, we…
The electronic structure and optical absorption spectrum of V^{0} and V^{-} center in MgO are investigated using first-principles calculations based on density functional theory. It is demonstrated that the configuration with distortion is…
We studied the ultrafast third-order optical nonlinearity in a single crystal of multiferroic bismuth ferrite (BiFeO3) in the near-infrared range of 0.5-1.0 eV, where the material is fundamentally transparent,at room temperature. With pump…
The anisotropic optical properties of multiferroic BiFeO$_3$ thin films have been determined with Mueller matrix ellipsometry at room-temperature. The full dielectric tensors of tetragonal-like and rhombohedral-like BiFeO$_3$ phases…
Using spectroscopic ellipsometry, the refractive index and absorption versus wavelength of the ferroelectric antiferromagnet Bismuth Ferrite, BiFeO_3 is reported. The material has a direct band-gap at 442 nm wavelength (2.81 eV). Using…
Ta$_{3}$N$_{5}$ is among the most intensively studied photoanode materials for solar-driven water oxidation, yet its performance often remains limited by short carrier lifetimes and defect mediated recombination. Although transient…
The electronic structures of ABO3 ferroelectrics are calculated within the density functional theory, and their evolution is analyzed as the crystal-field symmetry changes from cubic to rhombohedral via tetragonal phases. Electronic…
The rutile TiO$_2$ (110) surface reduced by the bridging oxygen vacancy, bridging hydroxyl group or Ti interstitial atom has been investigated by calculating their electronic structures using the density functional theory plus U method. It…
The energy and nuclear mass dependences of the total hadronic cross section in the energy range 0.5-2.6 GeV have been measured at Bonn using the SAPHIR tagged photon beam. The measurement, performed on C, Al, Cu, Sn and Pb, provides the…
Optical absorption spectra of higher fullerenes (C70 and C76) as well as of C60 are calculated by a tight binding model with a long range Coulomb interaction. A reasonable parameter set gives calculated spectra which are in overall…