Related papers: Sub-Array Selection in Full-Duplex Massive MIMO fo…
This paper studies the beamforming design problem of a multi-user downlink network, assuming imperfect channel state information known to the base station. In this scenario, the base station is equipped with multiple antennas, and each user…
This paper studies the cross-layer challenges and performance of Hybrid Beamforming (HBF) and Multi-User Multiple-Input Multiple-Output (MU-MIMO) in 5G millimeter wave (mmWave) cellular networks with full-stack TCP/IP traffic and MAC…
Beamforming is an effective means to improve the quality of the received signals in multiuser multiple-input-single-output (MISO) systems. Traditionally, finding the optimal beamforming solution relies on iterative algorithms, which…
In this work, we present a framework analysis of full-duplex (FD) systems for Millimeter Wave (mmWave) analog architecture. Given that FD systems can double the ergodic capacity, such systems experience large losses caused by the loopback…
Hybrid digital and analog beamforming is a highly effective technique for implementing beamforming methods in millimeter wave (mmWave) systems. It provides a viable solution to replace the complex fully digital beamforming techniques.…
Consider a multi-input multi-output (MIMO) downlink multi-user channel. A well-studied problem in such system is the design of linear beamformers for power minimization with the quality of service (QoS) constraints. The most representative…
In this paper, multi-stream transmission in interference networks aided by multiple amplify-and-forward (AF) relays in the presence of direct links is considered. The objective is to minimize the sum power of transmitters and relays by…
Multiuser beamforming is considered for partially-connected millimeter wave massive MIMO systems. Based on perfect channel state information (CSI), a low-complexity hybrid beamforming scheme that decouples the analog beamformer and the…
Hybrid beamforming is widely recognized as an important technique for millimeter wave (mmWave) multiple input multiple output (MIMO) systems. Generalized spatial modulation (GSM) is further introduced to improve the spectrum efficiency.…
Massive Multiple-input Multiple-output (MIMO) adaption is one of the primary evolving objectives for the next generation high speed train (HST) communication system. In this paper, we consider how to design an efficient low-complexity…
Multiple transmitting antennas can considerably increase the downlink spectral efficiency by beamforming to multiple users at the same time. However, multiuser beamforming requires channel state information (CSI) at the transmitter, which…
\underline{S}imultaneous \underline{t}ransmitting \underline{a}nd \underline{r}eflecting \underline{s}urface (STARS)-assisted systems have emerged to fill this gap by providing $ 360^{\circ}$ wireless coverage. In parallel, full-duplex (FD)…
We consider an integrated access and backhaul (IAB) node operating in full-duplex (FD) mode. We analyze simultaneous transmission from the New Radio gNB to the IAB node on the backhaul uplink, IAB node to a user equipment (UE) on the access…
A photonics-assisted analog wideband RF self-interference (SI) cancellation and frequency downconversion approach for in-band full-duplex (IBFD) multiple-input multiple-output (MIMO) systems with adaptive digital amplitude and delay…
This paper proposes a hybrid beamforming framework for massive multiple-input multiple-output (MIMO) in near-space airship-borne communications. To achieve high energy efficiency (EE) in energy-constraint airships, a dynamic subarray…
Hybrid beamforming is vital in modern wireless systems, especially for massive MIMO and millimeter-wave (mmWave) deployments, offering efficient directional transmission with reduced hardware complexity. However, effective beamforming in…
Long-term beamforming (LTBF) is a widely-used scalable alternative to instantaneous multi-user MIMO processing that leverages slowly varying spatial channel statistics. VLSI implementations require matrix inversion that become…
Future multi-input multi-output (MIMO) wireless communications systems will use beamforming as a first-step towards realizing the capacity requirements necessitated by the exponential increase in data demands. The focus of this work is on…
In this letter, the maximization of resistible jamming power is studied for multi-user downlink millimeter-wave cell-free multiple-input-multiple-output (CF-MIMO) systems. We propose an alternate optimization-based anti-jamming hybrid…
Beamforming has proven to be valuable in enabling full-duplex massive MIMO base stations, but doing so effectively often requires knowledge of the self-interference channel matrix H. Estimating this high-dimensional channel is costly in…