Related papers: Sub-Array Selection in Full-Duplex Massive MIMO fo…
In broadband millimeter-wave (mm-Wave) systems, it is desirable to design hybrid beamformers with common analog beamformer for the entire band while employing different baseband beamformers in different frequency sub-bands. Furthermore, the…
Existing beamforming-based full-duplex solutions for multi-antenna wireless systems often rely on explicit estimation of the self-interference channel. The pilot overhead of such estimation, however, can be prohibitively high in…
In this paper, we consider a multi-user wireless system with one full duplex (FD) base station (BS) serving a set of half duplex (HD) mobile users.To cope with the in-band self-interference (SI) and co-channel interference, we formulate a…
There is a demand for the same data content from several user equipments (UEs) in many wireless communication applications. Physical-layer multicasting combines the beamforming capability of massive MIMO (multiple-input multiple-output) and…
The combination of cell-free massive multiple-input multiple-output (CF-mMIMO) and reconfigurable intelligent surface (RIS) is envisioned as a promising paradigm to improve network capacity and enhance coverage capability. However, to reap…
Hybrid beamforming (HBF) is an attractive technology for practical massive multiple-input and multiple-output (MIMO) millimeter wave (mmWave) systems. Compared with the fully-connected HBF architecture, the partially-connected one can…
In this letter, we investigate the signal-to-interference-plus-noise-ratio (SINR) maximization problem in a multi-user massive multiple-input-multiple-output (massive MIMO) system enabled with multiple reconfigurable intelligent surfaces…
This paper presents the performance analysis of the self-interference cancellation (SIC) methods in full-duplex largescale multiple-input multiple-output systems. To mitigate selfinterference (SI), we assume that the full duplex-base…
The problem of the real-time multiple-input multiple-output (MIMO) array control when requirements on capacity performance, out-of-cell interference, and computational efficiency are simultaneously enforced is addressed by means of an…
This paper studies the benefits of incorporating underlaid full-duplex (FD) device-to-device (D2D) communications into massive multiple-input-multiple-output (MIMO) downlink systems. Due to the nature of cellular downlink and FD D2D…
This paper studies the coordinated beamforming design problem for the multiple-input single-output (MISO) interference channel, assuming only channel distribution information (CDI) at the transmitters. Under a given requirement on the rate…
Hybrid digital analog (HDA) beamforming has attracted considerable attention in practical implementation of millimeter wave (mmWave) multiuser multiple-input multiple-output (MU-MIMO) systems due to the low power consumption with respect to…
Hybrid beamforming (HBF) design is a crucial stage in millimeter wave (mmWave) multi-user multi-input multi-output (MU-MIMO) systems. However, conventional HBF methods are still with high complexity and strongly rely on the quality of…
This paper considers the design of the beamformers for a multiple-input single-output (MISO) downlink system that seeks to mitigate the impact of the imperfections in the channel state information (CSI) that is available at the base station…
The advancement of fifth generation (5G) wireless communication networks has created a greater demand for wireless resource management solutions that offer high data rates, extensive coverage, minimal latency and energy-efficient…
Owing to the unique advantages of low cost and controllability, reconfigurable intelligent surface (RIS) is a promising candidate to address the blockage issue in millimeter wave (mmWave) communication systems, consequently has captured…
In this paper, we propose a novel method for efficient implementation of a massive Multiple-Input Multiple-Output (massive MIMO) system with Frequency Division Duplexing (FDD) operation. Our main objective is to reduce the large overhead…
This letter develops an optimum beamforming method for downlink transmissions in cell-free massive multiple-input multiple-output (MIMO) systems, which employ a massive number of distributed access points to provide concurrent services to…
In this paper, we propose a wideband Full Duplex (FD) Multiple-Input Multiple-Output (MIMO) communication system comprising of an FD MIMO node simultaneously communicating with two multi-antenna UpLink (UL) and DownLink (DL) nodes utilizing…
This letter considers the secure communication in a reconfigurable intelligent surface (RIS) aided full duplex (FD) system. An FD base station (BS) serves an uplink (UL) user and a downlink (DL) user simultaneously over the same…