Related papers: Simulation study of BESIII with stitched CMOS pixe…

To detect tracks of charged particles close to the interaction point in high energy physics experiments of the next generation colliders, hybrid pixel detectors, in which sensor and read-out IC are separate entities, constitute the present…

The BeEST experiment is a precision laboratory search for physics beyond the standard model that measures the electron capture decay of $^7$Be implanted into superconducting tunnel junction (STJ) detectors. For Phase-III of the experiment,…

The ALICE Inner Tracking System has been recently upgraded to a full silicon detector consisting entirely of MAPS, arranged in seven concentric layers around the LHC beam pipe. Further ahead, during the LHC Long Shutdown 3, the ALICE…

The ALICE Inner Tracking System upgrade (ITS3) will employ stitched, wafer-scale Monolithic Active Pixel Sensors (MAPS) for the first time in high-energy physics, achieving a material budget of only 0.09$\,$%$\,$X$\mathrm{_{0}}$ per layer.…

An implementation of A Common Tracking Software (ACTS) toolkit for signal electron reconstruction for the COMET muon to electron conversion experiment is discussed. The COMET experiment in J-PARC, Japan, will search for neutrinoless…

Active Pixel Sensor (APS) technology has shown promise for next-generation vertex detectors. This paper discusses the design and testing of two generations of APS chips. Both are arrays of 128 by 128 pixels, each 20 by 20 micro-m. Each…

The reduction of the average charge per count in the gas along with the capability to discriminate very small signals from noise can allow an efficient and long-term Resistive Plate Chamber detector operation in high radiation background…

The efficiencies for electron and positron tracking and identification in the BESIII experiment are investigated with the radiative Bhabha process $e^+e^-\rightarrow e^+e^-\gamma$ from the data samples collected at the center-of-mass…

Following the Phase-II upgrade during Long Shutdown (LS3), the LHC aims to reach a peak instantaneous luminosity of $7.5\times 10^{34}$cm$^{-2}$s$^{-1}$, which corresponds to an average of around 200 inelastic proton-proton collisions per…

The Semiconductor Tracker (SCT) is a silicon strip detector and one of the key precision tracking devices in the Inner Detector of the ATLAS experiment at CERN LHC. The completed SCT has been installed inside the ATLAS experimental cavern…

The Cylindrical GEM-Inner Tracker (CGEM-IT) is the upgrade of the internal tracking system of the BESIII experiment. It consists of three layers of cylindrically-shaped triple GEMs, with important innovations with respect to the existing…

In this paper the status and prospects for BESIII is presented.The BEPCII machine is in good status and recently reached its highest luminosity of 7.08*10^32cm^-2s^-1. The BESIII detectors have been running stably since 2009. Upgrade plans…

The high integration density of MAPS, with silicon sensor and readout electronics implemented in the same device, allows very thin structures with a greatly reduced material budget. Thicknesses of $\mathcal{O}$(50~$\mu$m), values at which…

Most of the tracking detectors for high energy particle experiments are filled with silicon detectors since they are radiation hard, they can give very small spatial resolution and they can take advantage of the silicon electronics…

The current CMS silicon pixel detector as the innermost component of the CMS experiment is performing well at LHC design luminosity, but would be subject to severe inefficiencies at LHC peak luminosities of 2x10e34 cm^-2 s^-1. Therefore, an…

It is proposed to upgrade the endcap time-of-flight (ETOF) of the Beijing Spectrometer III (BESIII) with multi-gap resistive plate chamber (MRPC), aiming at overall time resolution about 80 ps. After the entire electronics system is ready,…

Run-2 of the Large Hadron Collider (LHC) will provide new challenges to track and vertex reconstruction with higher energies, denser jets and higher rates. Therefore the ATLAS experiment has constructed the first 4-layer Pixel Detector in…

During the LHC Long Shutdown 3 (2026-29) ALICE will replace its three innermost tracking layers by a new detector, the "ITS3". It will be based on newly developed, wafer-scale monolithic active pixel sensors, which are bent into truly…

While designed primarily for X-ray imaging applications, the Medipix3 ASIC can also be used for charged-particle tracking. In this work, results from a beam test at the CERN SPS with irradiated and non-irradiated sensors are presented and…

An efficient and precise reconstruction of charged-particle tracks is crucial for the overall performance of the CMS experiment. During Run 2 of LHC, significant upgrades were made to the track reconstruction algorithms in order to…