Related papers: In-situ multicore fibre-based pH mapping through o…
In this work, we investigate the impact of Fabry-Perot (FP) cavities formed between a fiber array and a silicon chip during edge-coupled testing of photonic integrated circuits (PICs). Our results show that subwavelength variations in the…
Micropumps are one of the most important parts of a microfluidic system. In particular, for biomedical applications such as Lab-on-Chip systems, micropumps are used to transport and manipulate test fluids in a controlled manner. In this…
We describe a microfluidic platform for solid phase screening using extremely small quantities of raw materials. Based on our previous setup for solubility measurement that generates saturated solutions directly from powder, the platform…
We report on fabrication of a microtoroid resonator of a high-quality factor (i. e., Q-factor of ~3.24x10^6 measured under the critical coupling condition) integrated in a microfluidic channel using femtosecond laser three-dimensional (3D)…
Small volume fluid handling in single and multiphase microfluidics provides a promising strategy for efficient bio-chemical assays, low-cost point-of-care diagnostics and new approaches to scientific discoveries. However multiple barriers…
Microfluidic devices offer unique opportunities to directly observe multiphase flow in porous media. However, as a direct representation of flow in geological pore networks, conventional microfluidics face several challenges. One is that…
The present work addresses the simulation of pore emptying during the drying of battery electrodes. For this purpose, a model based on the multiphase-field method (MPF) is used, since it is an established approach for modeling and…
High quality free-space and over-fibre transmission of mid-IR light is limited by factors such as material-related absorption, diffraction, light leakage and nonlinearity. Conventional vacuum apparatus can be utilized for high-quality…
Opto-mechanical oscillators that generate coherent acoustic waves are drawing much interest, in both fundamental research and applications. Narrowband oscillations can be obtained through the introduction of feedback to the acoustic wave.…
We propose using THz frequency selective surfaces interrogated with THz subwavelength optical fibers as sensors for monitoring of the optical properties of thick films that are brought in contact with such surfaces. Changes in the test film…
Waveguide-based interferometric circuits are widely employed in optical communications, sensing and computing applications. In particular, glass-based devices are appealing due to the transparency and bio-compatibility of this substrate, or…
Microscopic analysis of micro particles in situ in diverse water environments is necessary for monitoring water quality and localizing contamination sources. Conventional sensors such as optical microscopes and fluorometers often require…
Biosensors exploiting long-range surface plasmon polariton (LRSPP) waveguides comprised of Au stripes embedded in Cytop with integrated and encapsulated microfluidic channels are fabricated and demonstrated. A fabrication approach was…
Holographic multimode fibre endoscopes have recently shown their ability to unveil and monitor deep brain structures with sub-micrometre resolution, establishing themselves as a minimally-invasive technology with promising applications in…
We present a theoretical model for the evolution of mixture concentrations in a micro-pervaporation device, similar to those recently presented experimentally. The described device makes use of the pervaporation of water through a thin PDMS…
Mode division multiplexing (MDM) in optical fibers enables multichannel capabilities for various applications, including data transmission, quantum networks, imaging, and sensing. However, MDM optical fiber systems, usually necessities…
Optofluidic sensors based on highly dispersive two-dimensional photonic crystal waveguides are theoretically studied. Results show that these structures are strongly sensitive to the refractive index of the infiltrated liquid (nl), which is…
The mechanical performance of plant fibres is linked to the presence of crystalline elements dispersed within an amorphous cohesive matrix. The more the crystalline reinforcement is aligned with the fibre axis, the better the mechanical…
Precise manipulation of fluids and objects on the micro scale is seldom a simple task, but nevertheless crucial for many applications in life sciences and chemical engineering. We present a microfluidic chip fabricated in silicon-glass,…
The microfluidic probe (MFP) is a non-contact, scanning microfluidic technology for local (bio)chemical processing of surfaces based on hydrodynamically confining nanoliter volumes of liquids over tens of micrometers. We present here a…