Related papers: Highly efficient CdTe solar cell with a thin CIT c…
Solar modules are currently characterized at standard test conditions (STC), defined at 1000W/m2 and 25 {\deg}C. However, solar modules in actual outdoor operating conditions typically operate at lower illumination and higher temperature…
Sub-micrometer thin films are promising platforms for emerging flexible photovoltaic devices. Although the current market already produces efficient solar cells, the average wafer thickness of these devices remains far from the…
Flexible Cu2ZnSn(S, Se)4 (CZTSSe) solar cells take the advantages of environmental friendliness, low cost, and multi-scenario applications, and have drawn extensive attention in recent years. Compared with rigid devices, the lack of alkali…
Since the photoconversion efficiency $\eta$ of the silicon-based solar cells (SCs) under laboratory conditions is approaching the theoretical fundamental limit, further improvement of their performance requires theoretical modeling and/or…
Sulfide Kesterite Cu2ZnSnS4 (CZTS), a nontoxic and low-cost photovoltaic material, has always being facing severe charge recombination and poor carrier transport, resulting in the cell efficiency record stagnating around 11% for years.…
A few-micron thick structure that shows nearly 100% resonant polarized absorptance at a predefined midinfrared wavelength is designed and simulated. Like resonant-cavity enhanced photodetector structure, it contains a thin absorber enclosed…
We investigated the possibility of augmenting the fluence of electrons traversing CdTe thin film and thus increasing the detected signal pursuing two venues: adding a high-Z metal layer to the back of the detector surface, and adding a top…
The increase of cell efficiency resulting from using a diffraction grating as a back reflector is investigated. An enhancement coefficient is introduced as a figure of merit that accounts for the ability of the rear grating to increase the…
The efficiencies of solar cells based on kesterite Cu$_2$ZnSnS$_4$ (CZTS) and Cu$_2$ZnSnSe$_4$ (CZTSe) are limited by a low open-circuit voltage due to high rates of non-radiative electron-hole recombination. To probe the origin of this…
Cu2ZnSnS4 (CZTS) is a promising candidate as an absorber material for thin film solar cells. The reported wet chemical synthesis approaches often have a high environmental impact due to the usage of abrasive solvents such as hydrazines,…
In integrated photonics, specific wavelengths are preferred such as 1550 nm due to low-loss transmission and the availability of optical gain in this spectral region. For chip-based photodetectors, layered two-dimensional (2D) materials…
Nano-scaled metallic or dielectric structures may provide various ways to trap light into thin-film solar cells for improving the conversion efficiency. In most schemes, the textured active layers are involved into light trapping structures…
We obtain theoretical expressions for the photocurrent in the Heterojunction solar cells with Intrinsic Thin layer (HIT cells). Our calculations take into account tunneling of electrons and holes through wide-bandgap layers of $\alpha$-Si:H…
Thin film solar cells have been attractive for decades in advanced green technology platforms due to its possibilities to be integrated with buildings and on-chip applications. However, the bottleneck issues involved to consider the current…
Thin-film solar cells based on kesterite (Cu2ZnSnSe4) material are a promising alternative for photovoltaic devices due to their composition consisting of earth abundant elements, ease of production at a relatively low temperatures and…
We report a proof-of-concept two-terminal perovskite/Cu(In, Ga)Se2 (CIGS) monolithic thin-film tandem solar cell grown on ultra-thin (30-microns thick), light-weight, and flexible polyimide foil with a steady-state power conversion…
By application of the ac admittance spectroscopy method, the defect state energy distributions were determined in CdTe incorporated in thin film solar cell structures concluded on ZnO, ZnSe, and ZnS buffer layers. Together with the…
Currently, Sb$_2$Se$_3$ thin films receive considerable research interest as a solar cell absorber material. When completed into a device stack, the major bottleneck for further device improvement is the open circuit voltage, which is the…
The thermodynamic limit of photovoltaic efficiency for a single-junction solar cell can be readily predicted using the bandgap of the active light absorbing material. Such an approach overlooks the energy loss due to non-radiative…
Efficient semi-transparent solar cells can trigger the adoption of building integrated photovoltaics. Halide perovskites are particularly suitable in this respect owing to their tunable bandgap. Main drawbacks in the development of…