Related papers: Combinatorial Reactive Sputtering with Auger Param…
We report a phase-sensitive nonlinear x-ray response in the charge-density-wave material 1T-TaS2, revealed through x-ray parametric down-conversion into the ultraviolet. Extending nonlinear x-ray wave mixing beyond conventional crystalline…
A novel continuous-compositional spread technique based on the non-uniformity of the deposition rate typically observed in Pulsed Laser Deposition (PLD) is introduced. The approach uses the spatial variations in the deposition-rate…
Maximization saturation magnetic induction (Bs) of soft magnetic alloys is essential for the high power-density electromagnetic devices. However, identifying the alloy compositions with high Bs often replies on the lab-intensive melt…
Compositionally graded Fe-Pt thin films were prepared on stationary 100 mm Si substrates by magnetron sputtering a base target of Fe on which a piece of Pt is asymmetrically positioned. Energy Dispersive X-Ray analysis was used to map the…
In this paper we report structural and optical properties of Magnesium substituted Zinc Oxide (Zn1-xMgxO) nanocrystals (~10-12nm) synthesized by low temperature route. In the low temperature synthesis route it was possible to reach x = 0.17…
W0.75Re0.25, in its bulk form, has been shown to be an interesting superconducting material due to its multiple crystalline phases, each exhibiting distinct superconducting characteristics. However, little is known about how these phases…
We report on the superconducting properties of molybdenum nitride thin films grown by reactive DC sputtering at room temperature with a N2:Ar mixture. Thin films grown using 5 % N2 concentration display Tc = 8 K, which is gradually reduced…
ZnGeN2 and other heterovalent ternary semiconductors have important potential applications in optoelectronics, but ordering of the cation sublattice, which can affect the band gap, lattice parameters, and phonons, is not yet well…
We report on the synthesis of perovskite SrIrO3 thin films using sputtering technique. Single phase (110) oriented SrIrO$_3$ thin films were epitaxially grown on SrTiO3 (001) substrate. Using off-axis XRD $\theta-2\theta$ scans, we…
We have derived consistent sets of band parameters (band gaps, crystal field-splittings, band gap deformation potentials, effective masses, Luttinger and EP parameters) for AlN, GaN, and InN in the zinc-blende and wurtzite phases employing…
The recent observation of superconducting state at atomic scale has motivated the pursuit of exotic condensed phases in two-dimensional (2D) systems. Here we report on a superconducting phase in two-monolayer crystalline Ga films…
In this work, the authors fabricated Cu2O porous nanostructured films (PNFs) on glass slide substrates by the newly developed positive bias deposition approach in a balanced magnetron sputtering (MS) system. It was found that the surface…
Atom probe tomography enables precise quantification of the composition of second phase particles from their early stages, leading to improved understanding of the thermodynamic and kinetic mechanisms of phase formation and quantify…
Epitaxial thin films of stoichiometric ${\rm LaMnO_3}$ were grown on ${\rm SrTiO_3(110)}$ substrates using the pulsed laser deposition technique. From the high resolution x-ray diffraction measurements, the lattice parameters were…
Preparation of solid solutions represents an effective means to improve the photocatalytic properties of semiconductor-based materials. Nevertheless, the effects of site-occupancy disorder on the mixing stability and electronic properties…
g-C3N4 is a novel semiconductor photocatalyst material; however, the low specific surface area and rapid carrier compliance hinder its photocatalytic performance. On the other hand, the synthesis of 2D g-C3N4 with high crystallinity remains…
Nanoscale metallic multilayer (NMM) films are systems offering insight into the role of interfaces in metal plasticity, deformation, and strengthening mechanisms. Magnetron sputtering was used to fabricate the Ta-Cu NMM films with a…
The next generation of advanced materials is tending toward increasingly complex compositions. Synthesizing precise composition is time-consuming and becomes exponentially demanding with increasing compositional complexity. An experienced…
In the present work, ultrathin films of Zinc oxide (ZnO) and Aluminum doped zinc oxide (AZO) with 20 nm thick were fabricated at 300 K on glass and Polyethylene terephthalate (PET) substrates by means of directcurrent sputtering method. The…
Nb3Sn and V3Si thin films are promising candidates as thin films for the next generation of superconducting radio-frequency (SRF) cavities. However, sputtered films often suffer from stoichiometry and strain issues during deposition and…