Related papers: Programmable Transimpedance Amplifier with Integra…

The measurement of the biological tissue's electrical impedance is an active research field that has attracted a lot of attention during the last decades. Bio-impedances are closely related to a large variety of physiological conditions;…

This brief presents a technique for compensating the temperature coefficient (TC) of a bandgap reference (BGR) using temperature characteristics of transistor's current gain \b{eta}. As a comparison, three BGR circuits built with Si BJTs…

We present inverted metamorphic Ga0.3In0.7As photovoltaic converters with sub-0.60 eV bandgaps grown on InP and GaAs substrates. The compositionally graded buffers in these devices have threading dislocation densities of 1.3x10^6 cm^-2 and…

We compared the performance of a commercial ammeter and a home-made integrating electrometer in reading ionisation chamber currents less than 100 pA. The integrating electrometer charges a capacitor with the unknown current and measures the…

Adiabatic quantum-flux-parametron (AQFP) circuits can operate with extremely small energy dissipation (~1 zJ per junction at 5 GHz) and high sensitivity (~1 {\mu}A) owing to adiabatic switching. Thus, AQFP logic is suitable to use as…

The Large High Altitude Air Shower Observatory (LHAASO) project has been proposed for the survey and study of cosmic rays. In the LHAASO project, the Water Cherenkov Detector Array (WCDA) is one of major detectors for searching gamma ray…

The gain measurements of several 1 mm-thick, 10$\times$10 cm$^2$ Thick Gaseous Electron Multipliers (ThGEMs), operated in pure argon at 3.3 bar and room temperature are presented. Electrostatic simulations, performed with the COMSOL…

Glucose biosensors play an important role in the diagnosis and continued monitoring of the disease, diabetes mellitus. This report proposes the development of a novel enzymatic electrochemical glucose biosensor based on TiO$_2$ nanotubes…

This paper presents a compact programmable biphasic stimulator for cochlear implants. By employing double-loop negative feedback, the output impedance of the current generator is increased, while maximizing the voltage compliance of the…

n-TPA-IFA organic material was synthesized and deposited on p-Si by spin coating method to produce n-TPA-IFA/p-Si heterojunction diode. We determined that the dielectric constant and energy band gap of TPA-IFA organic material were 3.91 and…

This paper presents the uTCA4.0-based BPM electronics for PIP-II, featuring four 250 MSPS ADCs and a Xilinx UltraScale+ MPSoC FPGA with 10 GbE uplink. Design elements include signal conditioning, clock, and thermal management. The FPGA…

Characteristics of high sensitivity MEMS pressure sensor chip for 10 kPa utilizing a novel electrical circuit are presented. The electrical circuit uses piezosensitive differential amplifier with negative feedback loop (PDA-NFL) based on…

Piezoelectric optomechanical platforms present one of the most promising routes towards efficient transduction of signals from the microwave to the optical frequency domains. New device architectures need to be developed in order to achieve…

Accurate characterization of ferroelectric properties in polymer piezoelectrics is critical for optimizing the performance of flexible and wearable ultrasound transducers, such as screen-printed PVDF devices. Standard charge measurement…

HPgTPCs have benefits such as low energy threshold, magnetisability, and 4$\pi$ acceptance, making them ideal for neutrino experiments such as DUNE. We present the design of an FPGA-based solution optimised for ND-GAr, which is part of the…

Microwave sensors are very promising for sensing the blood glucose levels non-invasively for their non-ionizing nature, miniaturized sizing, and low health risks for diabetics. All these features offer the possibility for realizing a…

This paper presents a Gm-C dynamic amplifier with high linearity and high temperature and power supply voltage stability. The main part of the amplifier employs two asymmetric differential pairs to enhance transconductance linearity. The…

Conventional scanning tunneling microscopy (STM) is limited to a bandwidth of circa 1kHz around DC. Here, we develop, build and test a novel amplifier circuit capable of measuring the tunneling current in the MHz regime while simultaneously…

A new approach was developed for the design of front-end circuits for semiconductor radiation detectors. The readout scheme consists of a first stage made of only a few components located close to the detector, and of a remote second stage…

Diabetes is a prevalent chronic condition that compromises the health of millions of people worldwide. Minimally invasive methods are needed to prevent and control diabetes but most devices for measuring glucose levels are invasive and not…