Related papers: Precision measurement of an electron pump at 2 GHz
Bioimpedance measurements are a non-invasive method to determine the composition of organic tissue. For measuring the complex bioimpedance between two electrodes, an alternating current with a constant amplitude is injected into the tissue.…
We report a method to derive the potential barrier profile shape in a dynamic quantum dot and show the loading statistics, and hence accuracy of electron transfer, depend significantly on the shape of the barrier. This method takes a…
A simple, low-cost millimeter-wave (70 GHz) interferometer with a phase accuracy better than plus or minur 2 degrees, and a response time of 10 ns is described. The simplicity of this interferometer makes it ideal for measurement of…
We present a prescription for generating pure spin current or spin selective current, based on adiabatic quantum pumping in a tight-binding model of a one dimensional conductor. A formula for the instantaneous pumped current is derived…
This study demonstrates the feasibility of using smaller capillary emitters to achieve higher specific impulse ($I_\text{sp}$) in electrospray propulsion. Four ionic liquids were characterized using capillary emitters with tip diameters…
A circuit-simulation-based method is used to determine the thermally-induced bit error rate of superconducting logic circuits. Simulations are used to evaluate the multidimensional Gaussian integral across noise current sources attached to…
In this study, using only a single pulse, pump-probe measurement with a large time window of more than 100 ps is implemented. A commercial grating is used to encode a time window of ~ 56 ps in a single pulse; therefore, there is no need for…
An AC susceptometer operating in the range of 10 Hz to 100 kHz and at room temperature is designed, built, calibrated and used to characterize the magnetic behaviour of coated magnetic nanoparticles. Other weakly magnetic materials (in…
Experimental characterization of blood flow in living organisms is crucial for understanding the development and function of cardiovascular systems, but there have been no techniques reported for snapshot imaging of thick samples in large…
We present a method for measurements of electric dipole moments on (sub)-mm size (basalt) particles levitated in an acoustic trap and centered within a plate capacitor. If an electric field is applied the particles oscillate with specific…
We propose a method to perform accurate and fast charge pumping in superconducting nanocircuits. Combining topological properties and quantum control techniques based on shortcuts to adiabaticity, we show that it is theoretically possible…
This paper describes the realization of a two terminal-pair digital impedance bridge and the test measurements performed with it. The bridge, with a very simple architecture, is based on a commercial two-channel digital signal synthesizer…
We present a measurement of the hydrogen $2$S$_{1/2}-8$D$_{5/2}$ transition performed with a cryogenic atomic beam. The measured resonance frequency is $\nu=770649561570.9(2.0)$ kHz, which corresponds to a relative uncertainty of…
We describe the construction and operation of a segmented linear Paul trap, fabricated in printed-circuit-board technology with an electrode segment width of 500 microns. We prove the applicability of this technology to reliable ion…
Many modern electronic devices utilize linear Hall sensors to measure current and the magnetic field, as well as to perform switching and latching operations. Smartphones, laptops, and e-readers all work with very low (sub-mA) currents. To…
We report a highly sensitive all-fiber hydrogen sensor based on continuous-wave stimulated Raman gain spectroscopy with a hollow-core photonic crystal fiber operating around 1550 nm. A pump-probe configuration is used, in which the…
This proceeding summarizes recent measurements of electroweak boson and diboson production. The results, based on data from LHC Run 2 at $\sqrt{s}=13\,\mathrm{TeV}$ and Run 3 at $\sqrt{s}=13.6\,\mathrm{TeV}$, probe the Standard Model with…
A low noise constant current source used for measuring the $1/f$ noise in disordered systems in ohmic as well as non-ohmic regime is described. The source can supply low noise constant current starting from as low as 1 $\mu$A to a few tens…
This paper describes the results of the most recent measurement of the permanent electric dipole moment (EDM) of neutral $^{199}$Hg atoms. Fused silica vapor cells containing enriched $^{199}$Hg are arranged in a stack in a common magnetic…
The state of charge (SoC) and the rate of charging/discharging current are the vital parameters associated with a battery by which its accurate runtime can be estimated. This paper aims to design a controller which comprises of a…