Related papers: Multiple damage detection in piezoelectric ceramic…
The silicon nitride integration platform has been successful at realizing extremely low waveguide losses across the visible to infrared and components including high performance lasers, filters, resonators, stabilization cavities, and…
We observed that electric field induces phase transition from tetragonal to rhombohedral in polycrystalline morphotropic lead zirconate titanate (PZT) films, as reported in 2011 for bulk PZT. Moreover, we evidenced that this field-induced…
It is shown for the first time, that room temperature Ultrasonic Defect Manipulation (UDM) can significantly reduce the concentration of radiation defects in high resistivity silicon. Secondary Ion Mass Spectroscopy revealed that oxygen-…
The fundamental shear horizontal (SH0) wave in plate-like structures is of practical importance in structural health monitoring due to its non-dispersive characteristics. However, compared with Lamb wave, SH0 wave is less used in practice…
The effect of interface scattering on the performance of disordered, nanocomposite thermoelectric materials is studied theoretically using effective medium theory and direct numerics. The interfacial electronic and phonon scattering…
Magnesium alloys are emerging as promising alternatives to traditional orthopedic implant materials thanks to their biodegradability, biocompatibility, and impressive mechanical characteristics. However, their rapid in-vivo degradation…
This study investigates the imaging ability of the time-domain linear sampling method (TLSM) when applied to laser ultrasonic (LU) tomography of subsurface defects from limited-aperture measurements. In this vein, the TLSM indicator and it…
If driven sufficiently strongly, superconducting microresonators exhibit nonlinear behavior including response bifurcation. This behavior can arise from a variety of physical mechanisms including heating effects, grain boundaries or weak…
In this work, we present a Pt decorated ZnO thin film-based gas sensor for hydrogen detection, fabricated using a sputtering technique and an in-situ Pt decoration approach. Specifically, we deposit a ZnO thin film on an interdigitated…
We introduce a novel control mode for Scanning Tunneling Microscopy (STM) that leverages di/dz feedback. By superimposing a high-frequency sinusoidal modulation on the control signal, we extract the amplitude of the resulting tunneling…
Control of impurity concentrations in semiconducting materials is essential to device technology. Because of their intrinsic confinement, the properties of two-dimensional semiconductors such as transition metal dichalcogenides (TMDs) are…
In automatic target recognition (ATR) systems, sensors may fail to capture discriminative, fine-grained detail features due to environmental conditions, noise created by CMOS chips, occlusion, parallaxes, and sensor misalignment. Therefore,…
Semiconductors offer a promising platform for physical implementation of qubits, but their broad adoption is presently hindered by limited scalability and/or very low operating temperatures. Learning from the nitrogen-vacancy centers in…
Quantum sensors based on spin defect ensembles have seen rapid development in recent years, with a wide array of target applications. Historically, these sensors have used optical methods to prepare or read out quantum states. However,…
We have investigated a water-stable sol-gel method based on ethylene glycol as a solvent and bridging ligand for the synthesis of ferroelectric lead zirconate titanate in bulk and thin film forms. This method offers lower toxicity of the…
Laser ultrasonic non-destructive testing is widely used for the inspection of mechanical structures. This method uses the propagation of ultrasonic guided waves (UGW) in the media. For this purpose, it has been demonstrated that the…
The exceptional charge transport properties of single-walled carbon nanotubes (SWCNTs) enable numerous ultrafast optoelectronic applications. Modifying SWCNTs by introducing defects significantly impacts the performance of nanotube-based…
Hyperthermia therapy (HT) is used to treat diseases through heating of high temperature usually in conjunction with some other medical therapeutics like chemotherapy and radiotherapy. In this study, we propose a promising thermostatic…
SCAPS 1-D was used for the simulation of lead-free environmentally benign methylammonium tin-iodide (CH3NH3SnI3) based solar cell. Indium sulphide (In2S3) was utilized as the electron transport layer (ETL) for its high carrier mobility and…
The intermetallic compound ZnSb is an interesting thermoelectric material, largely due to its low lattice thermal conductivity. The origin of the low thermal conductivity has so far been speculative. Using multi-temperature single crystal…