Related papers: A simulation suite for readout with SMuRF tone-tra…
Several types of detectors are used to detect charged particles in particle and nuclear physics experiments. Since the semiconductor detector has superior spatial and kinematic resolutions as well as good response time than other types of…
The Locust simulation package is a new C++ software tool developed to simulate the measurement of time-varying electromagnetic fields using RF detection techniques. Modularity and flexibility allow for arbitrary input signals, while…
In this work, we report the experimental readout results of a {\mu}MUX device using a Direct-RF SDR prototype based on the ZCU216 Radio-Frequency System-on-Chip (RFSoC) evaluation board. First, the analog performance of the SDR system was…
The Simons Observatory (SO) is a cosmic microwave background experiment with over 67,000 polarization-sensitive transition-edge sensor (TES) detectors currently installed for use in observations and plans to increase the total detector…
Efficiently simulating large circuits is crucial to the development of superconducting nanowire-based electronics. However, current simulation tools for this technology are not adapted to the scaling of circuit size and complexity. We focus…
The ever-expanding scale of integrated circuits has brought about a significant rise in the design risks associated with radiation-resistant integrated circuit chips. Traditional single-particle experimental methods, with their iterative…
Arrays of low-temperature microcalorimeters provide a promising technology for X-ray astrophysics: the imaging spectrometer. A camera with at least several thousand pixels, each of which has an energy-resolving power ($E/\Delta…
Sub-Terahertz radio-stripe and distributed MIMO architectures promise extreme spatial reuse and multi-GHz bandwidths, but the cascaded fiber front-haul and RF hardware impairments strongly shape end-to-end performance. This paper presents…
This article presents the readout electronics of a novel beam monitoring system for ion research facility accelerator. The readout electronics are divided into Front-end Card (FEC) and Readout Control Unit (RCU). FEC uses Topmetal II minus…
Mainly due to their outstanding performance the position sensitive silicon detectors are widely used in the tracking systems of High Energy Physics experiments such as the ALICE, ATLAS, CMS and LHCb at LHC, the world's largest particle…
The microwave SQUID multiplexer (umux) has enabled higher bandwidth or higher channel counts across a wide range of experiments in particle physics, astronomy, and spectroscopy. The large multiplexing factor coupled with recent commercial…
Superconducting lithographed resonators have a broad range of current and potential applications in the multiplexed readout of cryogenic detectors. Here, we focus on LC bandpass filters with resonances in the 1-5 MHz range used in the…
Characterization of the frequency response of coherent radiometric receivers is a key element in estimating the flux of astrophysical emissions, since the measured signal depends on the convolution of the source spectral emission with the…
The ion-sensitive field-effect transistor (ISFET) is an emerging technology that has received much attention in numerous research areas, including biochemistry, medicine, and security applications. However, compared to other types of…
Various chips for the silicon sensors measurements are described. These chips are based on 0.35 um and 0.18um CMOS technology. Several analog chips together with self-trigger /derandomizer one allow to measure silicon sensors designed for…
We demonstrate radio frequency (RF) readout of electrically detected magnetic resonance in phosphorus-doped silicon metal-oxide field-effecttransistors (MOSFETs), operated at liquid helium temperatures. For the first time, the Si:P…
Recent years have shown an increased use of silicon photo-multipliers (SiPM) in experiments as they are of reasonable cost, have relatively low power consumption and are easily available in a variety of form factors allowing for a large…
This paper presents realistic system-level modelling and simulation of effective noise sources in a coupled resonating MEMS sensors. A governing set of differential equations are used to build a numerical model of a mechanical noise source…
Numerically optimised microwave pulses are used to increase excitation efficiency and modulation depth in electron spin resonance experiments performed on a spectrometer equipped with an arbitrary waveform generator. The optimisation…
Scanamorphos is one of the public softwares available to post-process scan observations performed with the Herschel photometer arrays. This post-processing mainly consists in subtracting the total low-frequency noise (both its thermal and…