Related papers: An FPGA-based Trigger System for CSHINE
The LBNF/DUNE CDR describes the proposed physics program and experimental design at the conceptual design phase. Volume 2, entitled The Physics Program for DUNE at LBNF, outlines the scientific objectives and describes the physics studies…
The planned high-luminosity upgrade of the Large Hadron Collider (LHC) at CERN will bring much higher data rates that are far above the capabilities of currently installed software-based data processing systems. Therefore, new methods must…
As the intensity of neutrino beams produced at accelerators increases, important systematic errors due to poor knowledge of production cross sections for pions and kaons arise. Among other goals, the NA61/SHINE (SHINE=SPS Heavy Ion and…
The Tangerine project aims to develop new state-of-the-art high-precision silicon detectors. Part of the project has the goal of developing a monolithic active pixel sensor using a novel 65 nm CMOS imaging process, with a small collection…
MINERvA (Main INjector ExpeRiment v-A) is a few-GeV neutrino scattering experiment that began taking data in the NuMI beam at Fermilab (FNAL) in the Fall of 2009. MINERvA employs a fine-grained detector, with an eight ton active target…
We present a microwave source that is controlled by a commercially available field programmable gate array (FPGA). Using an FPGA allows for precise control of the time dependent microwave-dressing applied to a sample of trapped cold atoms.…
The CDF-II experiment is a multipurpose detector designed to study a wide range of processes observed in the high energy proton-antiproton collisions produced by the Fermilab Tevatron. With event rates greater than 1MHz, the CDF-II trigger…
Graphene nanoribbons (GNRs) have been proposed as potential building blocks for field effect transistor (FET) devices due to their quantum confinement bandgap. Here, we propose a novel GNR device concept, enabling the control of both charge…
The Super Proton Synchrotron (SPS) at CERN covers one of the most interesting regions of the phase diagram (T - \mu_{B}) of strongly interacting matter. The study of central Pb+Pb collisions by NA49 indicate that the threshold for…
A prototype plastic scintillating fibre based beam profile monitor was tested at the Heidelberg Ion Therapy Centre / \textit{Heidelberg Ionenstrahl Therapiezentrum} (HIT) in 2016 to determine its beam property reconstruction performance and…
The increasing data rates and complexity of detectors at the Large Hadron Collider (LHC) necessitate fast and efficient machine learning models, particularly for rapid selection of what data to store, known as triggering. Building on recent…
The LHCb experiment at CERN is undergoing an upgrade in preparation for the Run 3 data taking period of the LHC. As part of this upgrade the trigger is moving to a fully software implementation operating at the LHC bunch crossing rate. We…
As the demands for railway transportation safety increase, traditional methods of rail track inspection no longer meet the needs of modern railway systems. To address the issues of automation and efficiency in rail fault detection, this…
This article presents a collection of simulation studies using the ECCE detector concept in the context of the EIC's exclusive, diffractive, and tagging physics program, which aims to further explore the rich quark-gluon structure of…
The Long Baseline Neutrino Facility (LBNF) will utilize a beamline located at Fermilab to provide and aim a neutrino beam of sufficient intensity and appropriate energy range toward the Deep Underground Neutrino Experiment (DUNE) detectors,…
The Pad Front End Board (pFEB) and the Strip Front End Board (sFEB) are developed for the ATLAS Phase-I sTGC Trigger Upgrade. The pFEB is used to to gather and analyze pads trigger, and the sFEB is developed to accept the pad trigger to…
NA61/SHINE is an experiment at the CERN Super Proton Synchrotron. The main goals of the experiment are the search for the critical point of strongly interacting matter and the study of the properties of the onset of deconfinement. To reach…
The Deep Underground Neutrino Experiment (DUNE) is a long-baseline (1300 km) neutrino experiment hosted at the Fermi National Accelerator Laboratory (FNAL). It aims to measure neutrino mass ordering and CP violation through neutrino…
In this work, a serial on-line cluster reconstruction technique based on FPGA technology was developed to compress experiment data and reduce the dead time of data transmission and storage. At the same time, X-ray imaging experiment based…
The planned neutrino program at Fermilab requires large proton beam intensities in excess of 2 MW. Measuring the transverse profiles of these high intensity beams is challenging and often depends on non-invasive techniques. One such…