Related papers: Simplified Efficiency Calibration Methods for Semi…
In this paper we present a method of scintillation detector energy calibration using the gamma-rays. The technique is based on the Compton scattering of gamma-rays in a scintillation detector and subsequent photoelectric absorption of the…
This paper describes an experimental setup that has been developed to measure and characterise properties of Silicon Photomultipliers (SiPM). The measured SiPM properties are of general interest for a multitude of potential applications and…
Measuring low light absorption with combined uncertainty < 1 permille is crucial in a wide range of applications. Popular cavity ring-down spectroscopy can provide ultra-high precision, below 0.01 permille, but its accuracy is strongly…
Single-photon source is the cornerstone for modern quantum information processing. The present work derives the theoretical limit of single-photon purity for general parametric heralded single-photon sources, and subsequently demonstrates a…
High-harmonic generation (HHG) is widely used for up-conversion of amplified (near) infrared ultrafast laser pulses to short wavelengths. We demonstrate that Ramsey-comb spectroscopy, based on two such pulses derived from a frequency-comb…
A distributed uranium source with the accurately certified activity of 238U has been used to verify the effective mass of the HPGe detector intended for the {\nu}GeN neutrino experiment. The source, dissolved in nitric acid, provides…
The low-energy monochromatic neutron emission from an Y-88/Be source can be exploited to mimic the few keVnr nuclear recoils expected from low-mass Weakly Interacting Massive Particles (WIMPs) and coherent scattering of neutrinos off…
Superconducting NbN wires have recently received attention as detectors for visible and infrared photons. We present experiments in which we use a NbN wire for high-efficiency (40 %) detection of single electrons with keV energy. We use the…
For its ease manufacturing, flexible geometry, and cheap manufacturing cost, the gas electron multiplier (GEM) detector can be used as an x-ray image sensor. For this purpose, we acquired relative detection efficiencies and suggested a…
Ultrafast, high quantum efficiency single photon detectors are among the most sought-after elements in modern quantum optics and quantum communication. High photon detection efficiency is essential for scalable measurement-based quantum…
A 100um thick silicon detector with 1mm2 pad readout optimized for sub-nanosecond time resolution has been developed and tested. Coupled to a purposely developed amplifier based on SiGe HBT technology, this detector was characterized at the…
We compare the standard 50%-efficient single beam splitter method for Bell-state measurement to a proposed 75%-efficient auxiliary-photon-enhanced scheme [W. P. Grice, Phys. Rev. A 84, 042331 (2011)] in light of realistic conditions. The…
We show a simple yet effective method that can be used to characterize the per pixel quantum efficiency and temporal resolution of a single photon event camera for quantum imaging applications. Utilizing photon pairs generated through…
High-purity germanium (HPGe) crystals underpin some of the most sensitive detectors used in fundamental physics and other high-resolution radiation-sensing applications. Despite their importance, the supply of detector-grade HPGe remains…
Detection systems rely more and more on on-line or off-line comparison of detected signals with basis signals in order to determine the characteristics of the impinging particles. Unfortunately, these comparisons are very sensitive to the…
InGaAs/InP single-photon detectors (SPDs) are widely used for near-infrared photon counting in practical applications. Photon detection efficiency (PDE) is one of the most important parameters for SPD characterization, and therefore…
The photon detection system for the LHCb RICH Upgrade consists of an array of multianode photomultiplier tubes (MaPMTs) read out by custom-built modular electronics. The behaviour of the whole chain was studied at CERN using a pulsed laser.…
We derive a computationally efficient expression of the photon counting distribution for a uniformly illuminated array of single photon detectors. The expression takes the number of single detectors, their quantum efficiency, and their…
In an ideal germanium detector, fully-absorbed monoenergetic gamma-rays will appear in the measured spectrum as a narrow peak, broadened into a Gaussian of width determined only by the statistical properties of charge cloud generation and…
Absolute normalisation of the LHC measurements with O(1%) precision and their relative normalisation, for the data collected at variable centre-of-mass energies, or for variable beam particle species, with O(0.1%) precision is crucial for…