Related papers: Controlling Flow Separation over a Curved Ramp Usi…
Droplet evaporation in turbulent sprays involves unsteady, multiscale and multiphase processes which make its comprehension and model capabilities still limited. The present work aims to investigate droplet vaporization dynamics within a…
Icing on three-dimensional wings causes severe flow separation near stall. Standard improved delayed detached eddy simulation (IDDES) is unable to correctly predict the separating reattaching flow due to its inability to accurately resolve…
Active flow control for drag reduction with reinforcement learning (RL) is performed in the wake of a 2D square bluff body at laminar regimes with vortex shedding. Controllers parameterised by neural networks are trained to drive two…
The work investigates the response dynamics of non-premixed jet flame to blast waves that are incident along the jet axis. In the present study, blast waves, generated using the wire-explosion technique, are forced to sweep across a…
The complex interaction between turbulence and the free surface in boundary layer shear flow created by a vertical surface-piercing wall is considered. A laboratory-scale device was built that utilizes a surface-piercing stainless steel…
The characteristics of pressure-induced laminar separation bubbles (LSBs) over a partially-slip wall, compared with that over a canonical no-slip wall, are studied using direct numerical simulation. Three cases, two utilizing linear…
This work is focused to study the development and control of the laminar vortex breakdown of a flow enclosed in a cylinder. We show that vortex breakdown can be controlled by the introduction of a small fixed rod in the axis of the…
We present a computational investigation of the mechanism governing size-based particle separation in microfluidic pinched flow fractionation. We study the behavior of particles moving through a pinching gap (i.e., a constriction in the…
This paper reports the bistability of curved compression ramp (CCR) flows. It reveals that both separation and attachment states can be stably established even for the same boundary conditions. Firstly, to investigate the effects of initial…
This paper presents a study on wave cancellation in forced jets. Building on recent work on real-time control of forced turbulent jets [1,2], we here assess the effect of jet upstream conditions and nonlinearity on wave-cancellation…
The drag reduction induced by superhydrophobic surfaces is investigated in turbulent pipe flow. Wetted superhydrophobic surfaces are shown to trap gas bubbles in their asperities. This stops the liquid from coming in direct contact with the…
A three-dimensional round liquid jet within a low-speed coaxial gas flow is numerically simulated and explained via vortex dynamics ($\lambda_2$ method). The instabilities on the liquid-gas interface reflect well the vortex interactions…
In this paper, the size of bubbles formed through the breakup of a gaseous jet in a co-axial microfluidic device is derived. The gaseous jet surrounded by a co-flowing liquid stream breaks up into monodisperse microbubbles and the size of…
Solution of a problem on the interaction mechanics of a free liquid jet with a flat plate, body and with other jet has been achieved by means of a graphic-analytical method, developed by author of the given article. This method has allowed…
In this paper we present the comparison of experiments and numerical simulations for bubble cutting by a wire. The air bubble is surrounded by water. In the experimental setup an air bubble is injected on the bottom of a water column. When…
A low-order method is presented for aerodynamic prediction of wings operating at near-stall and post-stall flight conditions. The method is intended for use in design, modeling, and simulation. In this method, the flow separation due to…
We report a detailed experimental characterization of the periodic bubbling regimes that take place in an axisymmetric air-water jet when the inner air stream is forced by periodic modulations of the pressure at the upstream air feeding…
In many engineering systems operating with a working fluid, the best efficiency is reached close to a condition of flow separation, which makes its prediction very crucial in industry. Providing that wall-based quantities can be measured,…
This study concerns a turbulent jet at Mach number $M_j=0.9$, subject to a uniform external flow stream at $M_f=0.15$. We assess the mechanisms that underpin the reduction in fluctuation energy that is known to occur when a jet is…
The present work develops a compressible VOF-LPT coupled solver in OpenFOAM and utilizes it to simulate a LJICF numerically. This methodology helps accurately predict a complex primary breakup in the Eulerian framework and the secondary…