Related papers: A Sampling Theorem for Exact Identification of Con…
Data-driven model predictive control based on Willems' fundamental lemma has proven effective for linear systems, but extending stability guarantees to nonlinear systems remains an open challenge. In this paper, we establish conditions…
The problem of system identification for the Kalman filter, relying on the expectation-maximization (EM) procedure to learn the underlying parameters of a dynamical system, has largely been studied assuming that observations are sampled at…
Both sampling a time-varying signal, and its spectral analysis are activities subjected to theoretically compelling, such as Shannon's theorem and the objectively limiting of the frequency's resolution. Usually, the signals' spectra are…
We present an approach to construct approximate Koopman-type decompositions for dynamical systems depending on static or time-varying parameters. Our method simultaneously constructs an invariant subspace and a parametric family of…
Spectroscopy sampling along delay time is typically performed with uniform delay spacing, which has to be low enough to satisfy the Nyquist-Shannon sampling theorem. The sampling theorem puts the lower bound for the sampling rate to ensure…
The Carleman linearization is one of the mainstream approaches to lift a finite-dimensional nonlinear dynamical system into an infinite-dimensional linear system with the promise of providing accurate approximations of the original…
This paper tackles the data-driven approximation of unknown dynamical systems using Koopman-operator methods. Given a dictionary of functions, these methods approximate the projection of the action of the operator on the finite-dimensional…
Compressive sensing (CS) is an alternative to Shannon/Nyquist sampling for the acquisition of sparse or compressible signals that can be well approximated by just K << N elements from an N-dimensional basis. Instead of taking periodic…
Dynamic mode decomposition (DMD) gives a practical means of extracting dynamic information from data, in the form of spatial modes and their associated frequencies and growth/decay rates. DMD can be considered as a numerical approximation…
This paper extends previous identification method to the asynchronous sampling scenario, enabling the simultaneous handling of asynchronous, non-uniform, and slow-rate sampling conditions. Moving beyond lumped systems, the proposed…
Takens' Embedding Theorem remarkably established that concatenating M previous outputs of a dynamical system into a vector (called a delay coordinate map) can be a one-to-one mapping of a low-dimensional attractor from the system state…
A general input-output modelling technique for aperiodic-sampling linear systems has been developed. The procedure describes the dynamics of the system and includes the sequence of sampling periods among the variables to be handled. Some…
We consider the problem of finite-time identification of linear dynamical systems from $T$ samples of a single trajectory. Recent results have predominantly focused on the setup where either no structural assumption is made on the system…
Time-dependent structural reliability analysis of nonlinear dynamical systems is non-trivial; subsequently, scope of most of the structural reliability analysis methods is limited to time-independent reliability analysis only. In this work,…
This paper proposes a Koopman-based framework for modeling, prediction, and control of unknown nonlinear time-varying systems. We present a novel Koopman-based learning method for predicting the state of unknown nonlinear time-varying…
This work continues the parametric investigation on the sampling nuances of the Dynamic Mode Decomposition (DMD) under the Koopman analysis. Through turbulent wakes, the investigation corroborated the generality of the universal convergence…
The CSL model predicts a progressive breakdown of the quantum superposition principle, with a noise randomly driving the state of the system towards a localized one, thus accounting for the emergence of a classical world within a quantum…
In this paper, we consider the task of designing a Kalman Filter (KF) for an unknown and partially observed autonomous linear time invariant system driven by process and sensor noise. To do so, we propose studying the following two step…
This paper addresses a structural design problem in control systems, and explicitly takes into consideration the possible application to large-scale systems. More precisely, we aim to determine and characterize the minimum number of…
The identification of a linear system model from data has wide applications in control theory. The existing work that provides finite sample guarantees for linear system identification typically uses data from a single long system…