Related papers: Improved Analysis of Current-Steering DACs Using E…
We study multi-user massive multiple-input single-output (MISO) systems and focus on downlink transmission, where the base station (BS) employs a large antenna array with low-cost 1-bit digital-to-analog converters (DACs). The direct…
In speech enhancement and source separation, signal-to-noise ratio is a ubiquitous objective measure of denoising/separation quality. A decade ago, the BSS_eval toolkit was developed to give researchers worldwide a way to evaluate the…
Too high sampling rate is the bottleneck to wideband spectrum sensing for cognitive radio in mobile communication. Compressed sensing (CS) is introduced to transfer the sampling burden. The standard sparse signal recovery of CS does not…
Analog electrical elements such as mixers, filters, transfer oscillators, isolating buffers, dividers, and even transmission lines contribute technical noise and unwanted environmental coupling in time and frequency measurements. Software…
In order to facilitate the analysis of timing relations between individual transitions in a signal trace, dynamic digital timing analysis offers a less accurate but much faster alternative to analog simulations of digital circuits. This…
The signal bandwidth of Digital to Analog Converters based on Sigma Delta Modulation is limited by speed constrains. Time-Interleaving allows coping with complexity vs. speed by replacing the original architecture by M parallel paths. These…
In this paper, we study the end-to-end distortion/delay tradeoff for a analogue source transmitted over a fading channel. The analogue source is quantized and stored in a buffer until it is transmitted. There are two extreme cases as far as…
Quantizers play a critical role in digital signal processing systems. Recent works have shown that the performance of quantization systems acquiring multiple analog signals using scalar analog-to-digital converters (ADCs) can be…
Stability guarantees are critical for cycle-by-cycle controlled dc-dc converters in consumer electronics and energy storage systems. Traditional stability analysis on cycle-by-cycle dc-dc converters is incomplete because the inductor…
The design and measurement results of ultra-low power, fast 10-bit Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) prototypes in 65 nm CMOS technology are presented. Eight prototype ADCs were designed using two…
- This paper describes a pipeline analog-to-digital converter is implemented for high speed camera. In the pipeline ADC design, prime factor is designing operational amplifier with high gain so ADC have been high speed. The other advantage…
In this paper, we provide an analytical framework for full-duplex (FD) massive multiple-input multiple-output (MIMO) cellular networks with low resolution analog-to-digital and digital-to-analog converters (ADCs and DACs). Matched filters…
The virtual synchronous generator (VSG), with the analogous nonlinear power-angle relationship to the synchronous generator (SG), has attracted much attention as a promising solution for converter-based power systems. In this paper, a large…
In this paper, the design flexibility of the control-bounded analog-to-digital converter principle is demonstrated. A band-pass analog-to-digital converter is considered as an application and case study. We show how a low-pass…
A prototype of a very high dynamic range 32-bits Digital to Analog Converter (DAC) was designed and built for the purpose of direct auditory stimulus generation. It provides signals from less than 100 nV up to 50 Watts peak power output,…
This paper presents the analysis and a method to design supplementary damping controllers (SDCs) for synchronous generators considering the effects of saturation limits. Usually such saturations of control signals are imposed in order to…
Partial resonance high frequency AC link converters are recognized to provide soft-switching, single-stage power conversion. They are highly reliable due to elimination of DC capacitors. Previous work has focused on proof of concept…
Sensor networks in which energy is a limited resource so that energy consumption must be minimized for the intended application are considered. In this context, an energy-efficient method for the joint estimation of an unknown analog source…
This paper presents an analytical framework for the data detection in massive multiple-input multiple-output uplink systems with 1-bit analog-to-digital converters (ADCs). Considering the single-user case, we provide closed-form expressions…
We consider a mixed analog-to-digital converter (ADC) based architecture for direction of arrival (DOA) estimation using a uniform linear array (ULA). We derive the Cram{\'e}r-Rao bound (CRB) of the DOA under the optimal time-varying…