Related papers: Closed-Loop MOEMS Accelerometer
Optomechanical accelerometers promise quantum-limited readout, high detection bandwidth, self-calibration, and radiation pressure stabilization. We present a simple, scalable platform that enables these benefits with nano-$g$ sensitivity at…
In this article, we present a deflection measurement setup for Atomic Force Microscopy (AFM). It is based on a quadrature phase differential interferometer: we measure the optical path difference between a laser beam reflecting above the…
Quantum-mechanical calculations of electron magnetotransport in graphene Fabry-P\'{e}rot interferometers are presented with a focus on the role of spatial structure of edge channels. For an interferometer that is made by removing carbon…
We report on efforts to improve the speed of low-G far-infrared transition-edged-sensed bolometers. We use a fabrication process that does not require any dry etch steps to reduce heat capacity on the suspended device and measure a…
Navigation, bio-tracking devices and gravity gradiometry are amongst the diverse range of applications requiring ultrasensitive measurements of acceleration. We describe an accelerometer that exploits the dispersive and dissipative coupling…
In the present work we develop an algorithm for calibrating MEMS sensors, which accounts for the nonorthogonality of the accelerometers' axis, as well as for the constant bias and scaling errors. We derive an explicit formula for computing…
The frequency-dependent amplitude and phase in piezoresponse force microscopy (PFM) measurements are shown to be a consequence of the Euler-Bernoulli (EB) dynamics of atomic force microscope (AFM) cantilever beams used to make the…
Fine assembly tasks such as electrical connector insertion have tight tolerances and sensitive components, requiring compensation of alignment errors while applying sufficient force in the insertion direction, ideally at high speeds and…
The engineering space for magnetically manipulated biomedical microrobots is rapidly expanding. This includes synthetic, bioinspired, and biohybrid designs, some of which may eventually assume clinical roles aiding drug delivery or…
We have developed and characterized two novel micro flow sensors based on measuring the electrical impedance of the interface between the flowing liquid and metallic electrodes embedded on the channel walls. These flow sensors are very…
We present an interferometric sensor for investigating macroscopic quantum mechanics on a table-top scale. The sensor consists of pair of suspended optical cavities with a finesse in excess of 100,000 comprising 10 g fused-silica mirrors.…
A Michelson-type interferometer with two-mode squeezed coherent state input is considered. Such an interferometer has a better phase sensitivity over the shot-noise limit by a factor of $e^{2r}$, where $r$ is the squeezing parameter [Phys.…
We demonstrate a Raman laser system based on phase modulation technology and phase feedback control. The two laser beams with frequency difference of 6.835 GHz are modulated using electro-optic and acousto-optic modulators, respectively.…
In a recent paper [18] the authors proposed the first solution to the problem of designing a {\em globally exponentially stable} (GES) flux observer for the interior permanent magnet synchronous motor. However, the establishment of the…
We design and experimentally demonstrate an architecture for achieving navigation-grade, fiber-packaged optomechanical accelerometers that can operate with a large dynamic range, over a wide temperature range, and without sophisticated…
A detailed analysis of the most relevant sources of phase noise in an atomic interferometer is carried out, both theoretically and experimentally. Even a short interrogation time of 100 ms allows our cold atom gravimeter to reach an…
We present a mathematical and numerical analysis on a control model for the time evolution of a multi-layered piezoelectric cantilever with tip mass and moment of inertia, as developed by Kugi and Thull [31]. This closed-loop control system…
We demonstrate a dual-axis accelerometer and gyroscope atom interferometer, which forms the building blocks of a six-axis inertial measurement unit. By recapturing the atoms after the interferometer sequence, we maintain a large atom number…
The control of beam phase relative to the accelerating RF field within a superconducting cavity is important in many accelerator applications and is of particular importance for a free electron laser facility. As standard practice, the…
The fields in multiple-pass interferometers, such as the Fabry--P\'erot cavity, exhibit great sensitivity not only to the presence but also to the motion of any scattering object within the optical path. We consider the general case of an…