Related papers: Full-Duplex Wideband mmWave Integrated Access and …
The future wireless communications are expected to provide new use scenarios with emerging techniques. This paper focuses on vehicle to everything (V2X) network, where vehicles should cooperatively implement information obtaining, data…
We investigate uplink user scheduling for millimeter wave (mmWave) hybrid analog/digital beamforming systems with low-resolution analog-to-digital converters (ADCs). Deriving new scheduling criteria for the mmWave systems, we show that the…
Millimeter-wave (mmWave) technology is one of the most promising candidates for future wireless communication systems as it can offer large underutilized bandwidths and eases the implementation of large antenna arrays which are required to…
The hybrid half-duplex/full-duplex (HD/FD) relaying scheme is an effective paradigm to overcome the negative effects of the self-interference incurred by the full-duplex (FD) mode. However, traditional hybrid HD/FD scheme does not consider…
The conventional digital beamforming technique needs one radio frequency (RF) chain per antenna element. High power consumption, significantly high cost of RF chain components per antenna and complex signal processing task at base band…
Digital beamforming and waveform generation techniques in MIMO radar offer enormous advantages in terms of flexibility and performance compared to conventional radar systems based on analog implementations. To allow for such fully digital…
In this paper we explore the use of full-duplex radio to improve the spectrum efficiency in a two-way relay channel where two sources exchange information through an multi-antenna relay, and all nodes work in the full-duplex mode. The…
In this work, we present a framework analysis of full-duplex (FD) systems for Millimeter Wave (mmWave) analog architecture. Given that FD systems can double the ergodic capacity, such systems experience large losses caused by the loopback…
Hybrid analog and digital beamforming has emerged as a key enabling technology for millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) communication systems since it can balance the trade-off between system performance…
Full-duplex (FD) technique can remarkably boost the network capacity in the millimeter wave (mmWave) bands by enabling simultaneous transmission and reception. However, due to directional transmission and large bandwidth, the throughput and…
In this paper, we present an Integrated Sensing and Communications (ISAC) system enabled by in-band Full Duplex (FD) radios, where a massive Multiple-Input Multiple-Output (MIMO) base station equipped with hybrid Analog and Digital (A/D)…
Millimeter wave (mmWave) multiple-input-multi-output (MIMO) is now a reality with great potential for further improvement. We study full-duplex transmissions as an effective way to improve mmWave MIMO systems. Compared to half-duplex…
This paper studies energy-efficient hybrid beamforming architectures and its algorithm design in millimeter-wave communication systems, aiming to address the challenges faced by existing hybrid beamforming due to low hardware flexibility…
Electronic analog to digital converters (ADCs) are running up against the well-known bit depth vs bandwidth tradeoff. Towards this end, RF photonic-enhanced ADCs have been the subject of interest for some time. Optical frequency comb…
Millimeter Wave (MmWave) communication is one of the key technology of the fifth generation (5G) wireless systems to achieve the expected 1000x data rate. With large bandwidth at mmWave band, the link capacity between users and base…
This work analyzes a mmWave single-cell network, which comprises a macro base station (BS) and an overlaid tier of small-cell BSs using a wireless backhaul for data traffic. We look for the optimal number of antennas at both BS and…
Despite the intensive recent research on wireless single-channel full-duplex communications, relatively little is known about the transceiver chain nonidealities of full-duplex devices. In this paper, the effect of nonlinear distortion…
Millimeter-wave (mmWave) communications and cell densification are the key techniques for the future evolution of cellular systems beyond 5G. Although the current mmWave radio designs are focused on hybrid digital and analog receiver array…
We aim at investigating the impact of low resolution digital-to-analog converters (DACs) at the transmitter and low resolution analog-to-digital converters (ADCs) at the receiver on the required bandwidth and the required signalto- noise…
Asynchronous distributed hybrid beamformers (ADBF) are conceived for minimizing the total transmit power subject to signal-to-interference-plus-noise ratio (SINR) constraints at the users. Our design requires only limited information…