Related papers: Full-Duplex Wideband mmWave Integrated Access and …
In this paper, we propose and evaluate a novel beamforming strategy for directional frame timing synchronization in wideband millimeter-wave (mmWave) systems operating with low-resolution analog-to-digital converters (ADCs). In the employed…
Conventional hybrid beamforming architectures are often compared with one another and with the fully-digital architecture under the same \emph{radiated} antenna power. However, the physically relevant budget is the power injected by the…
This paper analyzes the performance of the 3rd Generation Partnership Project (3GPP)-inspired multi-cell wideband single-hop backhaul millimeter-wave-in-band-full-duplex (IBFD)-integrated access and backhaul (IAB) networks by using…
Millimeter wave (mmWave) multi-user massive multi-input multi-output (MIMO) is a promising technique for the next generation communication systems. However, the hardware cost and power consumption grow significantly as the number of radio…
In this paper we study the spectral efficiency (SE) of a point-to-point massive multiple-input multiple-output system (P2P-massive MIMO) with limited radio frequency (RF) chains, i.e., analog-to-digital/ digital-to-analog (D2A/A2D) modules,…
This paper considers an ambient backscatter communication (AmBC) network in which a full-duplex access point (FAP) simultaneously transmits downlink orthogonal frequency division multiplexing (OFDM) signals to its legacy user (LU) and…
Recent achievement in self-interference cancellation algorithms enables potential application of full-duplex (FD) in 5G radio access systems. The exponential growth of data traffic in 5G can be supported by having more spectrum and higher…
Full-duplex self-backhauling is promising to provide cost-effective and flexible backhaul connectivity for ultra-dense wireless networks, but also poses a great challenge to resource management between the access and backhaul links. In this…
Communication systems with low-resolution analog-to-digital-converters (ADCs) can exploit channel state information at the transmitter (CSIT) and receiver. This paper presents initial results on codebook design and performance analysis for…
High power consumption and hardware cost are two barriers for practical massive multiple-input multiple-output (mMIMO) systems. A promising solution is to employ low-resolution analog-to-digital converters (ADCs). In this paper, we consider…
Photonic analog to digital conversion offers promise to overcome the signal-to-noise ratio (SNR) and sample rate trade-off in conventional analog to digital converters (ADCs), critical for modern digital communications and signal analysis.…
Analog/digital hybrid beamforming architectures with large-scale antenna arrays have been widely considered in millimeter wave (mmWave) communication systems because they can address the tradeoff between performance and hardware efficiency…
Due to the heavy reliance of millimeter-wave (mmWave) wireless systems on directional links, beamforming (BF) with high-dimensional arrays is essential for cellular systems in these frequencies. How to perform the array processing in a…
Massive multiple-input multiple-output (MIMO) avails of simple transceiver design which can tackle many drawbacks of relay systems in terms of complicated signal processing, latency, and noise amplification. However, the cost and circuit…
In this letter, we derive an approximate analytical expression for the uplink achievable rate of a massive multi-input multi-output (MIMO) antenna system when finite precision analog-digital converters (ADCs) and the common maximal ratio…
The use of unmanned aerial vehicle (UAV)-based communication in millimeter-wave (mmWave) frequencies to provide on-demand radio access is a promising approach to improve capacity and coverage in beyond-5G (B5G) systems. There are several…
A two-stage hybrid transceiver is designed by considering a partially connected architecture at the base station (BS) for a low-resolution multi-user (MU) THz massive multiple input multiple output (MIMO) system. Due to its high bandwidth…
The in-band Full Duplex (FD) technology is lately gaining attention as an enabler for the emerging paradigm of Integrated Sensing and Communications (ISAC), which envisions seamless integration of sensing mechanisms for unconnected entities…
Beamforming is an essential requirement to combat high pathloss and to improve signal-to-noise ratio during initial cell discovery in future millimeter wave cellular networks. The choice of an appropriate beamforming is directly coupled…
As a cost-effective alternative, hybrid analog and digital beamforming architecture is a promising scheme for millimeter wave (mmWave) system. This paper considers two hybrid beamforming architectures, i.e. the partially-connected and…