Related papers: High precision scalable power converter for accele…
Accurate measurements of alternating current (AC) and direct current(DC) ratios are fundamental to electric power metrology. However, conventional current comparators for AC and DC typically rely on distinct technologies-electromagnetic…
Switched-Capacitor Converters (SCC) suffer from a fundamental power loss deficiency which make their use in some applications prohibitive. The power loss is due to the inherent energy dissipation when SCC operate between or outside their…
Increasing datacenter demands require power-efficient optical interconnects. However, a conventional standard transmitter using a silicon rib-waveguide Mach-Zehnder modulator and voltage-mode driver has low efficiency and consumes…
ITER (International Thermonuclear Experimental Reactor) static magnetic field (SMF) test facility requires a DC power supply with low voltage, high current, and high stability. Due to the limitation ofswitching loss, there is a…
Partial resonance high frequency AC link converters are recognized to provide soft-switching, single-stage power conversion. They are highly reliable due to elimination of DC capacitors. Previous work has focused on proof of concept…
The accurate measurement of power converter currents is essential to controlling and delivering stable and repeatable currents to magnets in particle accelerators. This paper reviews the most commonly used devices for the measurement of…
A concept of a 650 MHz CW magnetron transmitter with fast control in phase and power, based on two-stage injection-locked CW magnetrons, has been proposed to drive Superconducting Cavities (SC) for intensity-frontier accelerators. The…
A light-emitting-diodes (LEDs)-integrated silicon carbide (SiC) insulated gate bipolar transistors (LI-IGBT) is proposed in this paper. The novelty of the LI-IGBT depends on the photogeneration effect of III-nitride LEDs embedded in the…
Silicon carbide (SiC) is an important semiconductor material for fabricating power electronic devices that exhibit higher switch frequency, lower energy loss and substantial reduction both in size and weight in comparison with its Si-based…
We design a resistive heater optimized for efficient and low-loss optical phase modulation in a silicon-on-insulator (SOI) waveguide and characterize the fabricated devices. Modulation is achieved by flowing current perpendicular to a new…
Advances in power electronics have made it possible to achieve high power levels, e.g., reaching GW in grids, or alternatively high output bandwidths, e.g., beyond MHz in communication. Achieving both simultaneously, however, remains…
A microwave rectifier at 5.8 GHz without any capacitors is presented, which owns a measured MW-to-DC conversion efficiency of 68.1%. A harmonic rejection filter and a DC pass filter, which replace lumped capacitors in conventional microwave…
In this paper we report on the development of a fast high-voltage switch, which is based on two enhancement mode N-channel Silicon Carbide Metal Oxide Semiconductor Field-Effect Transistors in push-pull configuration. The switch is capable…
A 12 bit Pipeline ADC fabricated in a 0.18 $\mu$m pure digital CMOS technology is presented. Its nominal conversion rate is 110MS/s and the nominal supply voltage is 1.8V. The effective number of bits is 10.4 when a 10MHz input signal with…
We develop a novel field effect transistor (FET) device using solid ion conductor (SIC) as a gate dielectric, and we can tune the carrier density of FeSe by driving lithium ions in and out of the FeSe thin flakes, and consequently control…
Electrified powertrains rely heavily on magnetics for power conversion, where cost, volume, and weight concerns make integrated multi-use designs an attractive solution. With EV powertrain architectures requiring a boost stage being a major…
This work presents a simple power converter, without any high voltage transformer, able to supply and control a plasma jet based on dielectric barrier discharge. The converter, operating in pulsed current mode, requires a single power…
The design and measurement results of ultra-low power, fast 10-bit Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) prototypes in 65 nm CMOS technology are presented. Eight prototype ADCs were designed using two…
Current-fed half bridge converter with bidirectional switches on ac side and a full bridge converter on dc side of a high frequency transformer is an optimal topology for single stage galvanically isolated ac-dc converter for onboard…
For an electron density near the H=0 insulator-to-conductor transition, the magnetoconductivity of the low-temperature conducting phase in high-mobility silicon MOSFETs is consistent with the form…