Related papers: Geometric tilt-to-length coupling in precision int…

This paper is the second in a set of two investigating tilt-to-length (TTL) coupling. TTL describes the cross-coupling of angular or translational jitter into an interferometric phase signal and is an important noise source in precision…

The coupling of the angular jitter of the spacecraft and their sub-assemblies with the optical bench and the telescope into the interferometric length readout will be a major noise source in the LISA mission. We refer to this noise as…

Objects sensed by laser interferometers are usually not stable in position or orientation. This angular instability can lead to a coupling of angular tilt to apparent longitudinal displacement -- tilt-to-length coupling (TTL). In LISA this…

This paper describes a setup aimed at measuring the so-called Tilt-To-Length (TTL) coupling in the optical benches of the LISA mission. The TTL is the coupling of the angular jitter of any optical setup into the optical path length between…

Tilts of certain elements within a laser interferometer can undesirably couple into measurements as a form of noise, known as tilt-to-length (TTL) coupling. This TTL coupling is anticipated to be one of the primary noise sources in the…

The arm length and the isolation in space enable LISA to probe for signals unattainable on ground, opening a window to the sub-Hz gravitational-wave universe. The coupling of unavoidable angular spacecraft jitter into the longitudinal…

Tilt-to-length (TTL) coupling in the Laser Interferometer Space Antenna (LISA) can generate spurious displacement noise that potentially affects the measurement of gravitational wave signals. In each test mass interferometer, the coupling…

For the LISA mission, Tilt-To-Length (TTL) coupling is expected to be one of the dominant instrumental noise contributions after laser frequency noise is suppressed based, on assumptions on the size of the coupling and angular jitter…

We present first-order models for tilt-to-length (TTL) coupling in LISA, both for the individual interferometers as well as in the time-delay interferometry (TDI) Michelson observables. These models include the noise contributions from…

Tilt-to-length coupling was the limiting noise source in LISA Pathfinder between 20 and 200 mHz before subtraction in post-processing. To prevent the adding of sensing noise to the data by the subtraction process, the success of this…

We present a study of the tilt-to-length coupling noise during the LISA Pathfinder mission and how it depended on the system's alignment. Tilt-to-length coupling noise is the unwanted coupling of angular and lateral spacecraft or test mass…

Tilt-to-length (TTL) noise from angular jitter in LISA is projected to be the dominant noise source in the milli-Hertz band unless corrected in post-processing. The correction is only possible after removing the overwhelming laser phase…

The Laser Interferometer Space Antenna (LISA) will be the first space-based gravitational wave (GW) observatory. It will measure gravitational wave signals in the frequency regime from 0.1 mHz to 1 Hz. The success of these measurements will…

Tilt-to-length (TTL) noise induced by angular jitter of spacecraft and test masses can affect the sensitivity of space-based gravitational-wave detectors such as LISA, Taiji, and TianQin. Such angular jitter can be measured using the…

Tilt-to-length (TTL) noise, caused by angular jitter and misalignment, is a major noise source in the inter-satellite interferometer for gravitational wave detection. However, the required level of axis alignment of the optical components…

The Laser Interferometer Space Antenna (LISA) mission features a three-spacecraft long-arm constellation intended to detect gravitational wave sources in the low-frequency band up to 1 Hz via laser interferometry. The paper presents an…

The Taiji mission for space-based gravitational wave (GW) detection employs laser interferometry to measure picometer-scale distance variations induced by GWs. The tilt-to-length (TTL) coupling noise in the inter-spacecraft interferometers,…

Tilt-to-length (TTL) coupling, caused by the jitter of test masses or satellites, is a significant noise source in space-based gravitational wave detection. Calibrating and suppressing TTL coupling noise at the sub-nanometer level is…

TianQin is a proposed space-based mission for gravitational wave detection, employing a constellation of three drag-free satellites in high Earth orbits to form a laser interferometric observatory. A critical technical challenge is…

Tilt-to-length (TTL) coupling is expected to be one of the major noise sources in the interferometric phase readouts in TianQin mission. Arising from the angular motion of spacecraft (SC) and the onboard movable optical subassemblies…