Related papers: A Portable Cosmic Ray Detector for School Educatio…
A substantial amount of important scientific information is contained within astronomical data at the submillimeter and far-infrared (FIR) wavelengths, including information regarding dusty galaxies, galaxy clusters, and star-forming…
A novel beam profiler based on microstructured scintillation resin is presented. The detector consists of a bundle of waveguides, with an active area of 30 x 30 mm$^2$ and a pitch of 400 $\mu$m, obtained by molding a scintillating resin…
The ICARUS detector is a liquid argon time projection chamber. It provides three dimensional imaging and calorimetry of ionizing particles over a large volume, with high granularity. Its Physics program includes the study of atmospheric,…
Galactic cosmic rays and solar energetic particles (SEPs) affect the performance of instruments carried on board space missions and are the source of the absorbed dose to astronauts. Particles above 100 MeV are the most penetrating. The…
Small low-cost instruments enable new and exciting mission opportunities yet their constrained volume and limited budgets make them especially susceptible to suffering anomalies during flight. Radiation effects as well as sensor or actuator…
The high computational expense of simulating light through ray-tracing in large, sparsely instrumented particle detectors such as IceCube and Antares is a critical outstanding problem in particle physics. When the detector is sparsely…
A compact beam-profile monitor was constructed using a linear contact image sensor attached to a plastic scintillator and tested using a 230 MeV proton beam. The results indicate that the beam distribution can be obtained in real-time, and…
Conceiving the possibility of using plastic scintillator bars as robust detectors for antineutrino detection for the remote reactor monitoring and nuclear safeguard application we study expected basic performance by Monte Carlo simulation.…
Tomographic imaging techniques using the Coulomb scattering of cosmic-ray muons are increasingly being exploited for the non-destructive assay of shielded containers in a wide range of applications. One such application is the…
A prototype of digital frequency multiplexing electronics allowing the real time monitoring of kinetic inductance detector (KIDs) arrays for mm-wave astronomy has been developed. It requires only 2 coaxial cables for instrumenting a large…
A large dynamic range is required by the Plastic Scintillator Detector (PSD) of DArk Matter Paricle Explorer (DAMPE), and a double-dynode readout has been developed. To verify this design, a prototype detector module has been constructed…
We have performed numerical simulations of the interplanetary transport of solar cosmic rays. The particles form a coherent pulse within $\sim0.01$ AU after their injection. The gradual decrease of a pulse's speed and anisotropy can be…
The Hubble Space Telescope (HST) has been operational for over 30 years and throughout that time it has been bombarded by high energy charged particles colloquially referred to as cosmic rays. In this paper, we present a comprehensive study…
Plastic scintillator detectors with three-dimensional granularity and sub-nanosecond time resolution offer simultaneous particle tracking, identification, and calorimetry. However, scaling to larger volumes and finer segmentation poses…
A new downstream tracking system, known as the Mighty Tracker, is planned to be installed at LHCb during LS4 of the LHC. This will allow an increase in instantaneous luminosity from $2\cdot10^{33}~\mathrm{cm}^{-2}\mathrm{s}^{-1}$ to…
Increasing interest towards the observation of the highest energy cosmic rays has motivated the development of new detection techniques. The properties of the Cherenkov photon pulse emitted in the atmosphere by these very rare particles…
This paper gives a description of a new on-line database http://lpsc.in2p3.fr/crdb and associated on-line tools (data selection, data export, plots, etc.) for charged cosmic-ray measurements. The experimental setups (type, flight dates,…
The space-based CUbesat Solar Polarimeter (CUSP) mission aims to measure the linear polarization of solar flares in the hard X-ray band by means of a Compton scattering polarimeter. CUSP will allow to study the magnetic reconnection and…
As part of the collaboration building a set of detectors for the new collider, our group was tasked with designing and building a large-scale cosmic ray detector, which was to complement the capabilities of the MPD (Dubna) detec-tor set.…
Timing-pick up detectors with excellent timing resolutions are essential in many modern nuclear physics experiments. Aiming to develop a Time-Of-Flight system with precision down to about 10 ps, we have made a systematic study of the timing…