Related papers: Improved superconducting qubit state readout by pa…
We demonstrate how the dissipative interaction between a superconducting qubit and a microwave photonic crystal can be used for quantum bath engineering. The photonic crystal is created with a step-impedance transmission line which…
Single-shot fidelity is the standard benchmark for superconducting qubit readout, yet it does not directly minimize the wall-clock time needed to certify a quantum state. We treat the dispersive measurement record as a stochastic…
We analyze a two qubit parity measurement based on dispersive read-out in circuit quantum electrodynamics. The back-action on the qubits has two qualitatively different contributions. One is an unavoidable dephasing in one of the parity…
Entangled multi-qubit states may be generated through a dispersive collective QND measurement of superconducting qubits coupled to a microwave transmission line resonator. Using the quantum trajectory approach, we analyze the stochastic…
We propose a protocol for two-qubit quantum phase gate based upon reflection of photon pulses from a quantum dot in a cavity. Depending on the state of the quantum dot the reflected photons acquire a conditional phase shift. The key…
Superconducting qubits typically use a dispersive readout scheme, where a resonator is coupled to a qubit such that its frequency is qubit-state dependent. Measurement is performed by driving the resonator, where the transmitted resonator…
A major challenge in operating multi-qubit quantum processors is to mitigate multi-qubit coherent errors. For superconducting circuits, besides crosstalk originating from imperfect isolation of control lines, dispersive coupling between…
We present a systematic study of the phase-coherent dynamics of a superconducting three-Josephson-junction flux qubit. The qubit state is detected with the integrated-pulse method, which is a variant of the pulsed switching DC SQUID method.…
We present a superconducting device that realizes the sequential measurement of a transmon qubit. The device disables common limitations of dispersive readout such as Purcell effect or transients in the cavity mode by turning on and off the…
Single-photon detection is an essential component in many experiments in quantum optics, but remains challenging in the microwave domain. We realize a quantum non-demolition detector for propagating microwave photons and characterize its…
Many superconducting qubit systems use the dispersive interaction between the qubit and a coupled harmonic resonator to perform quantum state measurement. Previous works have found that such measurements can induce state transitions in the…
Quantum computation will rely on quantum error correction to counteract decoherence. Successfully implementing an error correction protocol requires the fidelity of qubit operations to be well-above error correction thresholds. In…
High-fidelity quantum computation and quantum state transfer are possible in short spin chains. We exploit a system based on a dispersive qubit-boson interaction to mimic XY coupling. In this model, the usually assumed nearest-neighbors…
A class of optimal quantum repeaters for qubits is suggested. The schemes are minimal, i.e. involve a single additional probe qubit, and optimal, i.e. provide the maximum information adding the minimum amount of noise. Information gain and…
Quantum systems must be prepared, controlled, and measured with high fidelity in order to perform complex quantum algorithms. Control fidelities have greatly improved in silicon spin qubits, but state preparation and readout fidelities have…
Single-shot readout is a key component for scalable quantum information processing. However, many solid-state qubits with favorable properties lack the single-shot readout capability. One solution is to use the repetitive…
Quantum illumination is a protocol for detecting a low-reflectivity target by using two-mode entangled states composed of signal and idler modes, which can outperform unentangled states. We study multi-qudit states for single-shot detection…
We use microwave radiation generated by a semiconductor double quantum dot (DQD) micromaser for charge state detection. A cavity is populated with n_c ~ 6000 photons by driving a current through an emitter DQD. These photons are used to…
In quantum computing, precise control of system-environment coupling is essential for high-fidelity gates, measurements, and networking. We present an architecture that employs an artificial giant atom from waveguide quantum electrodynamics…
Fast and accurate qubit measurement remains a critical challenge on the path to fault-tolerant quantum computing. In superconducting quantum circuits, fast qubit measurement has been achieved using a dispersively coupled resonator with a…