Related papers: Hypersonic curved compression ramp flows with bist…
The transition route and bifurcations of the buoyant flow developing on a heated circular horizontal surface are elaborated using direct numerical simulations and direct stability analysis. A series of bifurcations, as a function of…
Linear stability of supersonic flow over a short compression corner with ramp angles 30 and 42 is investigated using Direct Simulation Monte Carlo (DSMC) and Linear Stability Theory (LST) at Mach number 3, Reynolds number 11,200 and low…
Since it is difficult to apply the existing method of friction and heat flux decomposition on the complex surface, a combined decomposition method of friction and heat flux with clear physical interpretation is proposed, which is based on…
A high-fidelity simulation of the shock/transitional boundary layer interaction caused by a 15-degrees axisymmetrical compression ramp is performed at a freestream Mach number of 5 and a transitional Reynolds number. The inlet of the…
The structural properties of an economical model for a confined plasma turbulence governor are investigated through bifurcation and stability analyses. A close relationship is demonstrated between the underlying bifurcation framework of the…
This work presents a combined experimental and theoretical study of dynamic contact angle hysteresis using liquid bridges under cyclic compression and stretching between two identical plates. Under various loading rates, contact angle…
In this study, we numerically investigate hysteretic behaviors of secondary bifurcations in the Taylor-Couette flow of a semidilute, neutrally buoyant, and noncolloidal suspension. We consider a suspension with a bulk particle volume…
This work uncovers the low-dimensional nature the complex dynamics of actuated separated flows. Namely, motivated by the problem of model-based predictive control of separated flows, we identify the requirements on a model-based observer…
The intakes of air-breathing high-speed flying vehicles produce a large share of the thrust propulsion. Furthermore, the propulsion performance of these engines increases when the single-ramp intake is replaced with a multiple-ramps intake.…
The corner roll (CR) in the Rayleigh-B\'{e}nard (RB) convection accounts for the behaviors of heat transport and convection flow at the corner. Streamlines of the three-dimensional direct numerical simulations for $10^8<Ra<5\times10^9$ show…
Mixing and heat transfer rates are typically enhanced when operating at high-pressure transcritical turbulent flow regimes. The rapid variation of thermophysical properties in the vicinity of the pseudo-boiling region can be leveraged to…
We report two different types of backflow from jets by performing 2D special relativistic hydrodynamical simulations. One is anti-parallel and quasi-straight to the main jet (quasi-straight backflow), and the other is bent path of the…
Main characteristics of colloidal systems that develop fluid phases with different mechanical properties, namely shear-banding fluids, are briefly reviewed both from experimental and theoretical (modelling) point of view. A non-monotonic…
We present a detailed study of of a global bifurcation occuring in a turbulent von K\'arm\'an swirling flow. In this system, the statistically steady states progressively display hysteretic behaviour when the Reynolds number is increased…
The behaviour in simple shear of two concentrated and strongly cohesive mineral suspensions showing highly non-monotonic flow curves is described. Two rheometric test modes were employed, controlled stress and controlled shear-rate. In…
In this paper we present a constitutive model to describe unsaturated flow that considers the hysteresis phenomena. This constitutive model provides simple mathematical expressions for both saturation and hydraulic conductivity curves, and…
The separated flow over a wall-mounted bump geometry under harmonic oscillations of the inflow stream is investigated by direct numerical simulations. The bump geometry gives rise to streamwise pressure gradients similar to those…
The coil-stretch transition in extensional flows of viscoelastic dilute polymer solutions is known to be associated with a strong hysteresis in molecular conformations and rheo-optical properties. At infinite dilution, hysteresis is caused…
The yielding of concentrated cohesive suspensions can be deformation-rate dependent. One consquence of this is that a single suspension can present in one several different ways, depending upon how it is tested, or more generally, how it is…
Compound flows consist of two or more parallel compressible streams in a duct and their theoretical treatment has gained attention for the analysis and modelling of ejectors. Recent works have shown that these flows can experience choking…