Related papers: An Optical Voltage Sensor Based on Piezoelectric T…
We propose a novel radio-frequency (RF) receiving architecture based on micro-electro-mechanical system (MEMS) and optical coherent detection module. The architecture converts the received electrical signal into mechanical vibration through…
We present a compact current sensor based on a superconducting microwave lumped-element resonator with a nanowire kinetic inductor, operating at 4.2 K. The sensor is suitable for multiplexed readout in GHz range of large-format arrays of…
This work focuses on the development and demonstration of tunable superconducting on-chip resonator, leveraging the intrinsic current-dependent non-linear kinetic inductance of superconducting aluminium, and investigating the effect of…
We describe and demonstrate a method by which the nonlinear piezoelectric properties of a piezoelectric material may be measured by detecting the force that it applies on a suspended micromechanical resonator at one of its mechanical…
We measure the transmission secondary electron yield of nanometer-thick Al$_2$O$_3$/TiN/Al$_2$O$_3$ films using a prototype version of a Timed Photon Counter (TiPC). We discuss the method to measure the yield extensively. The yield is then…
We propose a spintronic strain sensor capable of sensing strain with a sensitivity of 1E-13/sqrt{Hz} at room temperature with an active sensing area of 1 cmE2 and power dissipation of 1 watt. This device measures strain by monitoring the…
If driven sufficiently strongly, superconducting microresonators exhibit nonlinear behavior including response bifurcation. This behavior can arise from a variety of physical mechanisms including heating effects, grain boundaries or weak…
The superconducting Transition-Edge Sensor (TES) is a critical technology for next-generation X-ray spectrometers, known for its exceptional energy resolution. In the last decade, TESs based on AlMn alloy films have been extensively used in…
RF sputtered ZnO and Al:ZnO films are attractive transparent conductive oxides for fabrication of opto-electronic devices. In this paper we present efforts to control carrier concentration and mobility of ZnO/Al:ZnO thin films by…
The present distribution grids generally have limited sensing capabilities and are therefore characterized by low observability. Improved observability is a prerequisite for increasing the hosting capacity of distributed energy resources…
We present the first detection of electrons with kinetic energy in the 100 eV range with transition-edge sensors (TESs). This has been achieved with a $(100\times 100)$ $\mu$m$^2$ Ti-Au bilayer TES, with a critical temperature of about 84…
We present the use of a commercially available fixed-angle multi-wavelength ellipsometer for quickly measuring the thickness of NbN thin films for the fabrication and performance improvement of superconducting nanowire single photon…
The increasing number of distributed generators connected to distribution grids requires a reliable monitoring of such grids. Economic considerations prevent a full observation of distribution grids with direct measurements. First…
Through its dependence on low symmetry crystal phases, ferroelectricity is inherently a property tied to the lower temperature ranges of the phase diagram for a given material. This paper presents conclusive evidence that in the case of…
Accurate prediction of chip performance is critical for ensuring energy efficiency and reliability in semiconductor manufacturing. However, developing minimum operating voltage ($V_{min}$) prediction models at advanced technology nodes is…
Aluminum nitride (AlN) plays a key role in modern power electronics and deep-ultraviolet photonics, where an understanding of its thermal properties is essential. Here we measure the thermal conductivity of crystalline AlN by the…
Photonic integrated circuits (PICs) are crucial for advancing optical communications, promising substantial gains in data transmission speed, bandwidth, and energy efficiency compared to conventional electronics. Telecom-wavelength…
The fabrication processes of silicon nitride photonic devices used in foundries require low temperature deposition, which typically leads to high propagation losses. Here, we show that propagation loss as low as 0.42 dB/cm can be achieved…
Based on grating diffraction principle, optical fiber transmission principle and optical interference principle, a multi-functional portable optical measuring instrument is constructed in this paper. The optical measurement visualization…
A highly sensitive refractive index sensor based on grating-assisted strip waveguide directional coupler is proposed. The sensor is designed using two coupled asymmetric strip waveguides with a top-loaded grating structure in one of the…