Related papers: Depth-dependent charge collection profile of pad d…
We report an experimental refinement of the local charge density at the Si (111) 7x7 surface utilizing a combination of x-ray and high energy electron diffraction. By perturbing about a bond-centered pseudoatom model, we find experimentally…
Supercapacitors are promising electrochemical energy storage devices due to their prominent performance in rapid charging/discharging rates, long cycle life, stability, etc. Experimental measurement and theoretical prediction on charging…
We analytically calculate the correlation potential of a test ion near a \emph{strongly} charged plate inside a dilute $m:-n$ electrolyte. We do this by calculating the electrostatic Green's function in the presence of a nonlinear…
Subsurface Charge Accumulation imaging is a cryogenic scanning probe technique that has recently been used to spatially probe incompressible strips formed in a two-dimensional electron system (2DES) at high magnetic fields. In this paper,…
The aim of this work is to classify the aerospace structure defects detected by eddy current non-destructive testing. The proposed method is based on the assumption that the defect is bound to the reaction of the probe coil impedance during…
This paper introduces a constructive method for approximating relative continuum measurements in two-dimensional electrical impedance tomography based on data originating from either the point electrode model or the complete electrode…
The current CMS silicon pixel detector as the innermost component of the CMS experiment is performing well at LHC design luminosity, but would be subject to severe inefficiencies at LHC peak luminosities of 2x10e34 cm^-2 s^-1. Therefore, an…
We report on measurements of the electrical conductivity in both a 2D triangular lattice of metallic beads and in a chain of beads. The voltage/current characteristics are qualitatively similar in both experiments. At low applied current,…
We examine interferometric measurements of the topological charge of (non-Abelian) anyons. The target's topological charge is measured from its effect on the interference of probe particles sent through the interferometer. We find that…
Charge collection properties of depleted CMOS pixel detector prototypes produced on p-type substrate of 2 k$\Omega$cm initial resistivity (by LFoundry 150 nm process) were studied using Edge-TCT method before and after neutron irradiation.…
We analyze the problem of quantum-limited estimation of a stochastically varying phase of a continuous beam (rather than a pulse) of the electromagnetic field. We consider both non-adaptive and adaptive measurements, and both dyne detection…
We introduce a generalized non-uniform mean-field formalism to describe the dissociation of weak rod-like polyelectrolytes (PEs). Our approach allows for two-sublattice symmetry breaking which in titration curves is associated with a…
Herein, charged microbeads handled with optical tweezers are used as a sensitive probe for simultaneous measurements of electrophoretic and dielectrophoretic forces. We first determine the electric charge carried by a single bead by keeping…
This study presents a comprehensive analysis of a two-level battery charger for electric vehicles, focusing on modeling, simulation, and performance evaluation. The proposed charger topology employs two switches operating complementarily,…
An extensive sensor testing campaign is presented, dedicated to measuring the charge collection properties of prototype candidates for the Vertex Locator (VELO) detector for the upgraded LHCb experiment. The charge collection is measured…
This paper reports on the fabrication and characterization of a high purity monocrystalline diamond detector with buried electrodes realized by the selective damage induced by a focused 6 MeV carbon ion beam scanned over a pattern defined…
The current understanding of charge transfer dynamics in Charge-Coupled Devices (CCDs) is that charge is moved so quickly from one phase to the next in a clocking sequence and with a density so low that trapping of charge in the inter-phase…
Electrical Impedance Tomography (EIT) is a powerful tool for non-destructive evaluation, state estimation, and process tomography - among numerous other use cases. For these applications, and in order to reliably reconstruct images of a…
Ionic behaviors, including ion distributions and hydration characteristics at solid-liquid interfaces, are important research interests in many important applications, such as electric double-layer capacitors and water lubrication. Here, we…
We present the performance and application of a commercial off-the shelf Si PIN diode (Hamamatsu S14605) as a charged particle detector in a compact ion beam system (IBS) capable of generating D-D and p-B fusion charged particles. This…