Related papers: Robust Analog Beamforming for Periodic Broadcast V…
In this paper, we study the average throughput performance of energy beamforming in a multi-antenna wireless-powered communication network (WPCN). The considered network consists of one hybrid access-point (AP) with multiple antennas and a…
This paper considers a multiple-input multiple-output (MIMO) integrated sensing and communication (ISAC) system, where a multi-antenna base station (BS) with transceiver hybrid analog-digital arrays transmits dual-functional signals to…
This paper proposes a narrowband fully-analog $N$-antenna transmitter that emulates the functionality of a narrowband fully-digital $N$-antenna transmitter. Specifically, in symbol interval $m$, the proposed fully-analog transmitter…
In this letter, we investigate the performance of multiple-input multiple-output techniques in a vehicle-to-vehicle communication system. We consider both transmit antenna selection with maximal-ratio combining and transmit antenna…
Hybrid beamforming via large antenna arrays has shown a great potential for increasing data rate in cellular networks by delivering multiple data streams simultaneously. In this paper, several beamforming design algorithms are proposed…
Hybrid analog and digital (HAD) beamforming has been recently receiving considerable deserved attention for a practical implementation on the large-scale antenna systems. As compared to full digital beamforming, partial-connected HAD…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
High-mobility uncrewed aerial vehicle (UAV) communications in low-altitude wireless networks (LAWN) demand reliable beamforming, while conventional feedback-based schemes suffer from excessive overhead and severe misalignment under rapid…
In millimeter-wave communication systems with large-scale antenna arrays, conventional digital beamforming may not be cost-effective. A promising solution is the implementation of hybrid beamforming techniques, which consist of…
In this paper, we propose an analog beamsteering approach for enabling flexible hybrid beamforming design that can achieve performance close to singular value decomposition (SVD) based digital beamforming with single user case. As a…
This paper investigates a new analog beamforming architecture for massive multiple-input multiple-output (MIMO) systems, where each of the multiple transmit antennas is switched to be on or off to form a beam according to the channel state…
Movable antenna (MA) technology offers promising potential to enhance wireless communication by allowing flexible antenna movement. To maximize spatial degrees of freedom (DoFs), larger movable regions are required, which may render the…
A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…
Hybrid beamforming for frequency-selective channels is a challenging problem as the phase shifters provide the same phase shift to all of the subcarriers. The existing approaches solely rely on the channel's frequency response and the…
The beamforming techniques have been recently studied as possible enablers for underlay spectrum sharing. The existing beamforming techniques have several common limitations: they are usually system model specific, cannot operate with…
Classical beamforming techniques rely on highly linear transmitters and receivers to allow phase-coherent combining at the transmitter and receiver. The transmitter uses beamforming to steer signal power towards the receiver, and the…
A simple method is proposed for use in a scenario involving a single-antenna source node communicating with a destination node that is equipped with two antennas via multiple single-antenna relay nodes, where each relay is subject to an…
In this paper, we consider a synthetic aperture secure beamforming approach for a virtual multiple-input multiple output (MIMO) broadcast channel in the presence of hybrid wiretapping environments. Our goal is to design the flight node…
Research has shown that communications systems and receivers suffer from high power adjacent channel signals, called blockers, that drive the radio frequency (RF) front end into nonlinear operation. Since simple systems, such as the…
Modern wireless communication networks, particularly cellular networks utilize multiple antennas to improve the capacity and signal coverage. In these systems, typically an active transceiver is connected to each antenna. However, this…