Related papers: Comparison between Thermoelectric and Bolometric M…
Recent developments of the AC-calorimetric technique adapted for the needs of high pressure experiments are discussed. A semi-quantitative measurement of the specific heat with a Bridgman-type of pressure cell as well as a diamond anvil…
For superconducting quantum processors, microwave signals are delivered to each qubit from room-temperature electronics to the cryogenic environment through coaxial cables. Limited by the heat load of cabling and the massive cost of…
The bulk Micromegas detector is considered to be a promising candidate for building TPCs for several future experiments including the projected linear collider. The standard bulk with a spacing of 128 micron has already established itself…
We present proof-of-operation for a new method of electron thermometry using microwave impedance of a hafnium micro-absorber. The new method leads to an ultimate THz-range detector suitable for microwave readout and frequency division…
Plasma diagnostics have a shortage of fast and sensitive calorimetric sensors that can track substrate temperature during plasma-assisted microfabrication. In this work, energy fluxes from argon and oxygen radiofrequency (RF) glow…
We describe the design, fabrication, and testing of a broadband log-periodic antenna coupled to multiple cryogenic bolometers. This detector architecture, optimized here for astrophysical observations, simultaneously receives two linear…
The Tenerife Microwave Spectrometer (TMS) is a ground-based radio-spectrometer that will take absolute measurements of the sky between 10-20 GHz. To ensure the sensitivity and immunity to systematic errors of these measurements, TMS…
In this paper, the calorimetric power measurement method for electron cyclotron resonance heating system on EAST are presented. This method requires measurement of the water flow through the cooling circuits and the input and output water…
Heat transport in low-dimensional solids can significantly differ from their bulk counterpart due to various size-related effects. This offers rich heat transport phenomena to emerge. However, finding an appropriate thermometry method for…
Fast, high-fidelity measurement is a key ingredient for quantum error correction. Conventional approaches to the measurement of superconducting qubits, involving linear amplification of a microwave probe tone followed by heterodyne…
While the thermal and electromagnetic properties of plasmonic nanostructures are well understood, nanoscale thermometry still presents an experimental and theoretical challenge. Plasmonic structures can confine electromagnetic energy at the…
We present a Michelson-type microwave interferometer for use in ferromagnetic resonance experiments. The interferometer is capable of broadband operation without manual adjustment of phase delay or amplitude attenuation. A prototype of the…
We present a scheme and demonstrate measurements of a Coulomb blockade thermometer (CBT) in a microwave transmission setup. The sensor is embedded in an $LCR$ resonator, where $R$ is determined by the conductance of the junction array of…
The POLARBEAR-2 CosmicMicrowave Background (CMB) experiment aims to observe B-mode polarization with high sensitivity to explore gravitational lensing of CMB and inflationary gravitational waves. POLARBEAR-2 is an upgraded experiment based…
Quantum metrology has been shown to surpass classical limits of correlation, resolution, and sensitivity. It has been introduced to interferometric Radar schemes, with intriguing preliminary results. Even quantum-inspired detection of…
We present measurements of the electrical and thermal properties of new arrays of bolometeric detectors that were fabricated as part of a program to develop bolometers optimized for the low photon background of the EBEX balloon-borne…
The fundamentals of the whispering gallery mode (WGM) resonators are well established in the literature, with several successful proof-of-concept experiments. One remarkable benefit of this technology is the room-temperature operation. This…
We studied noise properties of microwave signals transmitted through the cryogenic resonator. The experiments were performed with the 11.342 GHz sapphire loaded cavity resonator cooled to 6.2 K. Based on the measured transmission…
Understanding heat transport is relevant to develop efficient strategies for thermal management in microelectronics for instance, as well as for fundamental science purposes. However, measuring temperatures in nanostructured environments…
Microcalorimeters are used by National Metrology Institutes (NMI) for the realization of the Radiofrequency and Microwaves (RF&MW) primary power standard. Since they are not available on the market, NMIs have to design their own systems. It…