Related papers: Microresonator devices lithographically introduced…
Many uses of lasers place the highest importance on access to specific wavelength bands. For example, mobilizing optical-atomic clocks for a leap in sensing requires compact lasers at frequencies spread across the visible and near infrared.…
Large-scale microfluidic microsystems with complex three-dimensional (3D) configurations are highly in demand by both fundamental research and industrial application, holding the potentials for fostering a wide range of innovative…
Suspended optical microresonators are promising devices for on-chip photonic applications such as radio-frequency oscillators, optical frequency combs, and sensors. Scaling up these devices demand the capability to tune the optical…
Opto-mechanical oscillators that generate coherent acoustic waves are drawing much interest, in both fundamental research and applications. Narrowband oscillations can be obtained through the introduction of feedback to the acoustic wave.…
We present a novel approach to realize microresonator-comb-based high resolution spectroscopy that combines a fiber-laser cavity with a microresonator. Although the spectral resolution of a chip-based comb source is typically limited by the…
Vibrating nano- and micromechanical resonators have been the subject of research aiming at ultrasensitive mass sensors for mass spectrometry, chemical analysis and biomedical diagnosis. Unfortunately, their merits diminish dramatically in…
With the advent of microsphere assisted microscopy in 2011, this technique emerged as a simple and easy way to obtain optical super-resolution. Although the possible mechanisms of imaging by microspheres are debated in the literature, most…
Optical nanofibers confine light to subwavelength scales, and are of interest for the design, integration, and interconnection of nanophotonic devices. Here we demonstrate high transmission (> 97%) of the first family of excited modes…
Optical parametric oscillation (OPO) is distinguished by its wavelength access, that is, the ability to flexibly generate coherent light at wavelengths that are dramatically different from the pump laser, and in principle bounded solely by…
We propose to use high numerical aperture single mode optical fibers like photonic crystal fiber for lensless in-line holographic microscopy. Highly divergent beam helps to overcome the spatial sampling limitation of the image sensor. In…
Lithium niobate is a promising material for developing quantum acoustic technologies due to its strong piezoelectric effect and availability in the form of crystalline thin films of high quality. However, at radio frequencies and cryogenic…
We describe a reproducible method of fabricating adiabatic tapers with 3-4 micron diameter. The method is based on a heat-and-pull rig, whereby a CO2 laser is continuously scanned across a length of fiber that is being pulled synchronously.…
An external-cavity diode laser is reported with ultralow noise, high power coupled to a fiber, and fast tunability. These characteristics enable the generation of an optical frequency comb in a silica micro-resonator with a single-soliton…
Optical frequency division based on bulk or fiber optics provides unprecedented spectral purity for microwave oscillators. To extend the applications of this approach, the big challenges are to develop miniaturized optical frequency…
Robust control and stabilization of optical frequency combs enables an extraordinary range of scientific and technological applications, including frequency metrology at extreme levels of precision, novel spectroscopy of quantum gases and…
We demonstrate low loss ridge waveguides and the first ring resonators for the mid-infrared, for wavelengths ranging from 5.4 to 5.6 {\mu}m. Structures were fabricated using electron-beam lithography on the silicon-on-sapphire material…
Kerr nonlinearity based frequency combs and solitons have been generated from on-chip optical microresonators with high quality factors and global or local anomalous dispersion. However, fabrication of such resonators usually requires…
We present a design for a tunneling-current-assisted scanning near-field microwave microscope. For stable operation at cryogenic temperatures, making a small and rigid microwave probe is important. Our coaxial resonator probe has a length…
Microwaves generated by optical techniques have demonstrated unprecedentedly low noise and hold significance in various applications such as communication, radar, instrumentation, and metrology. To date, the purest microwave signals are…
Control of dispersion in fibre optical waveguides is of critical importance to optical fibre communications systems and more recently for continuum generation from the ultraviolet to the mid-infrared. The wavelength at which the group…