Related papers: Quantifying residual stress in Helium implanted su…
The study of vesicles in suspension is important to understand the complicated dynamics exhibited by cells in vivo and in vitro. We developed a computer simulation based on the boundary-integral method to model the three dimensional…
This paper presents a broad theoretical and simulation study of the high temperature behavior of crystalline alkali halide surfaces typified by NaCl(100), of the liquid NaCl surface near freezing, and of the very unusual partial wetting of…
Alkali halide (100) crystal surfaces are poorly wetted by their own melt at the triple point. We carried out simulations for NaCl(100) within the well tested BMHFT model potential. Calculations of the solid-vapor, solid-liquid and…
Point defects such as interstitial atoms are known to be attracted to screw dislocations. Understanding these interaction mechanisms is key to predicting the plasticity of real materials. Using a new machine learning interatomic potential…
Low dimensional quantum fluids, where one can probe the effects of enhanced thermal and quantum fluctuations on macroscopic quantum wavefunctions, can be experimentally realized through transverse physical confinement of superfluid helium…
Compacted unsaturated swelling clay is often considered as a possible buffer material for deep nuclear waste disposal. An isotropic cell permitting simultaneous control of suction, temperature and pressure was used to study the…
When a suspension freezes, a compacted particle layer builds up at the solidification front with noticeable implications on the freezing process. In a directional solidification experiment of monodispersed suspensions in thin samples, we…
In this paper we present a modeling approach to bridge the atomistic with macroscopic scales in crystalline materials. The methodology combines identification and modeling of the controlling unit processes at microscopic level with the…
Dispersing small particles in a liquid can produce surprising behaviors when the solids fraction becomes large: rapid shearing drives these systems out of equilibrium and can lead to dramatic increases in viscosity (shear-thickening) or…
3He nanobubbles created by radioactive decay of tritium in palladium tritide are investigated after several years of aging. Scanning Transmission Electron Microscopy Electron Energy-Loss Spectroscopy (STEM-EELS) has been used to measure…
We investigate the effect of helium abundance and $\alpha$-element enhancement on the properties of convection in envelopes of solar-like main-sequence stars stars using a grid of 3D radiation hydrodynamic simulations. Helium abundance…
Dynamics of a bubble impacting and sliding a tilted surface has been investigated through experimental and computational methods. \textcolor{blue}{Specifically, shear stress generated on the wall has been calculated and compared with…
We report a combined experimental and theoretical study of the melting curve and the structural behavior of vanadium under extreme pressure and temperature. We performed powder x-ray diffraction experiments up to 120 GPa and 4000 K,…
Nanoindentation is a widely used method for sensitive exploration of the mechanical properties of micromechanical systems. We derived an empirical analysis technique to extract stress-strain field gradient and divergence representations…
We present the formulation for finding the distribution of eigenstrains, i.e. the sources of residual stress, from a set of measurements of residual elastic strain (e.g. by diffraction), or residual stress, or stress redistribution, or…
Liquid metals exhibit remarkable mechanical properties, in particular large surface tension and low viscosity. However, these properties are greatly affected by oxidation when exposed to air. We measure the viscosity, surface tension, and…
We investigate the effects of the reversal of the gravitational field onto a sedimented and partially crystallised suspension of nearly-hard sphere colloids. We analyse the structural changes that take place during the melting of the…
We simulate a dense athermal suspension of soft particles sheared between hard walls of a prescribed roughness profile, using a method that fully accounts for the fluid mechanics of the solvent between the particles, and between the…
We have produced and observed metastable solid helium-4 below its melting pressure between 1.1 K and 1.4 K. This is achieved by an intense pressure wave carefully focused inside a crystal of known orientation. An accurate density map of the…
We use experiments to study the dynamics of the healing of a blister, a localized bump in a thin elastic layer that is adhered to a soft substrate everywhere except at the bump. We create a blister by gently placing a glass cover slip on a…