Related papers: Single Stage PFC Flyback AC-DC Converter Design

DC microgrids conform to distributed control of renewable energy sources which ratifies efficacious instantaneous power sharing and sustenance of energy access among different domestic Power Management Units (PMUs) along with maintaining…

An increasing integration of photovoltaic units, electric vehicle chargers, heat pumps, and energy storage systems challenges low-voltage power grids and can cause voltage range violation, loss of stability, (local) overload of lines, and…

Current-steering digital-to-analog converter (DAC) is a prominent architecture that is commonly used in high-speed applications such as optical communications. One of the shortcomings of this architecture is the output glitches that are…

Frequency conversion (FC) is an enabling process in many quantum information protocols. Recently, it has been observed that upconversion efficiencies in single-photon, mode-selective FC are limited to around 80%.In this letter we argue that…

The connection of single-phase microgrids (MG) and loads to three-phase MGs creates power quality problems such as unbalanced voltage and voltage rise at the point of common coupling (PCC) of the MGs. In this paper, a modified reverse droop…

Conventional analog-to-digital converters (ADCs) fail to capture high-dynamic-range (HDR) signals due to clipping. Modulo ADCs circumvent this limitation by folding the input prior to quantization and algorithmically reconstructing the…

Phase-shifted carrier pulse-width modulation (PSC-PWM) is a widely adopted scheduling algorithm in cascaded bridge converters, modular multilevel converters, and reconfigurable batteries. However, non-uniformed pulse widths for the modules…

We present an ultra-low noise, high-voltage driver suited for use with piezoelectric actuators and other low-current applications. The architecture uses a flyback switching regulator to generate up to 250V in our current design, with an…

In railway applications, it is common to use an LC filter connected between the catenary and the input port of the main converter of the auxiliary and traction systems. In addition, in the auxiliary systems, there is a converter operating…

Parameter design is significant in ensuring a satisfactory holistic performance of power converters. Generally, circuit parameter design for power converters consists of two processes: analysis and deduction process and optimization…

The field-circuit coupled simulation of switch-mode power converters with conventional time discretization is computationally expensive since very small time steps are needed to appropriately account for steep transients occurring inside…

In this paper a CMOS two stage operational amplifier has been presented which operates at 1.8 V power supply at 0.18 micron (i.e., 180 nm) technology and whose input is depended on Bias Current. The op-amp provides a gain of 63dB and a…

This paper presents an efficient dual-band rectifier for radiofrequency energy harvesting (RFEH) applications at FM and GSM bands. The single-port rectifier circuit, which comprises a 3-port network, optimized T-matching circuits and…

This letter proposes a general decentralized control of cascaded inverters-power factor angle droop control. Compared to the existing control strategies, it has the following attractive benefits: 1) it is suitable for both grid-connected…

The low-voltage ride-through service is carried out in this paper according to the voltage profile described by the IEC 61400-21 European normative when short-duration voltage sags happen, and some instantaneous reactive power is delivered…

Modular Multilevel Converter-based High Voltage Direct Current (MMC-HVDC) system is a promising technology for integration of offshore wind farms (OWFs). However, onshore AC faults on MMC-HVDC reduce the power transfer capability of onshore…

Conventional SSHI (synchronized switch harvesting on inductor) has been believed to be one of the most efficient interface circuits for piezoelectric vibration energy harvesting systems. It employs an inductor and the resulting RLC loop to…

In [1] a new adaptive phase-locked loop scheme for synchronization of a grid connected voltage source converter with guaranteed (almost) global stability properties was reported. To guarantee a suitable synchronization with the angle of the…

An inverter is generally employed with MV LFT to connect to the grid in a grid-tied PV system. However, in some single-stage topologies, the LFTs are replaced by HFT combined with an unfolder inverter. Generally, these topologies have…

This study focuses on optimizing the design parameters of a Dual Active Bridge (DAB) converter for use in 350 kW DC fast chargers, emphasizing the balance between efficiency and cost. Addressing the observed gaps in existing high-power…