Related papers: Sol-gel synthesis of Li3VO4/C composites as anode …
Low temperature rechargeable batteries are important to life in cold climates, polar/deep-sea expeditions and space explorations. Here, we report ~ 3.5 - 4 V rechargeable lithium/chlorine (Li/Cl2) batteries operating down to -80 {\deg}C,…
Olivine-type LiFePO$_{4}$ is widely considered as a candidate for Li-ion battery electrodes, yet its applicability in the pristine state is limited due to poor ionic and electronic conduction. Doping can be employed to enhance the…
Solid polymer electrolytes for lithium batteries promise improvements in safety and energy density if their conductivity can be increased. Nanostructured block copolymer electrolytes specifically have the potential to provide both good…
Blend solid polymer electrolyte based on PEO, PVP complexed with lithium LiBOB were synthesized by solution cast technique and impact of LiBOB on the morphology, structure, and electrochemical properties is examined. The XRD and FESEM…
In this work, the structural stability and the electronic properties of LiNiBO 3 and LiFe x Ni (1-x) BO 3 are studied using first principle calculations based on density functional theory. The calculated structural parameters are in good…
For a successful integration of silicon in high-capacity anodes of Li-ion batteries, its intrinsic capacity decay on cycling due to severe volume swelling should be minimized. In this work, Ni-Sn intermetallics are studied as buffering…
Na, K and Ca-ion battery electrode materials with appropriate electrochemical properties are desirable candidates for replacing lithium-ion batteries (LIBs) because of their natural richness and low cost. Recently, MoO2 has been reported as…
Layered-oxide $\mathrm{LiNi_xMn_yCo_{1-x-y}O_2}$ (NMC) positive electrodes with high Nickel content, deliver high voltages and energy densities. However, a high nickel content, e.g., $x$ = 0.8 (NMC 811), can lead to high surface reactivity,…
Cubic spinel lithium manganese oxide (LiMn2O4) has been able to attract a great deal of attention over the years as a promising cathode material for large scale lithium ion batteries. Here a facile hydrothermal route followed by solid state…
Non-aqueous Li-O2 batteries are promising for next generation energy storage. New battery chemistries based on LiOH, rather than Li2O2, have recently been reported in systems with added water, one using a soluble additive LiI and the other…
Silicon-containing lithium-ion batteries can exhibit capacity gain early in life, which makes forecasting future cell behavior difficult. We have observed these anomalous trends even in conditions where known mechanisms, such as overhang…
Nanomaterials are anticipated to be promising storage media, owing to their high surface-to-mass ratio. The high hydrogen capacity achieved by using graphene has reinforced this opinion and motivated investigations of the possibility to use…
Lithium metal batteries (LMB) are vital devices for high-energy-density energy storage, but Li metal anode is highly reactive with electrolyte and forms uncontrolled dendrite that can cause undesirable parasitic reactions thus poor cycling…
The growing demand for efficient energy storage has driven the search for advanced anode materials for lithium- and sodium-ion batteries (LIBs and SIBs). In this context, we report the application of HOP-graphene (a 5-6-8-membered 2D carbon…
Finding electrode materials with high capacity is a key challenge for developing Lithium-ion batteries (LIBs). Graphene was once expected to be a promising candidate, but it turns out to be too inert to interact with Li. Here, by using the…
Lithium fluorinated carbon is one of the most promising chemistries for high-energy-density primary energy storage systems in applications where rechargeability is not required. Though Li/CFx demonstrates high energy density under ambient…
As a new type of self-healing material, room-temperature liquid metal (LM) composed of Ga, In and Sn is a promising anode in lithium-ion batteries (LIBs). It is difficult to directly prepare an electrode slurry with pure LM. Here, the LM…
This paper explores the mechanical behaviour of the composite materials used in modern lithium-ion battery electrodes. These contain relatively high modulus active particle inclusions within a two-component matrix of liquid electrolyte…
We examine a new NASICON-type Na$_4$NiCr(PO$_4$)$_3$ material designed for high-voltage and multi-electron reactions for the sodium-ion batteries (SIBs). The Rietveld refinement of the X-ray diffraction pattern, using the R$\bar{3}$c space…
We report simultaneous dissolution of agarose (AG) and chitosan (CH) in varying proportions in an ionic liquid (IL), 1-butyl-3-methylimidazolium chloride [C4mim][Cl]. Composite materials were constructed from AG-CH-IL solutions using the…