Related papers: Optimal Two-way TOA Localization and Synchronizati…
In this paper, we propose time and frequency synchronization techniques for uplink multiuser OTFS (MU-OTFS) systems in high-mobility scenarios. This work focuses on accurately estimating and correcting timing offsets (TOs) and carrier…
For radio-based time-of-arrival (TOA) positioning systems applied in harsh environments, obstacles in the surroundings and on the vehicle itself will block the signals from the anchors, reduce the number of available TOA measurements and…
Ultra-wideband positioning systems intended for indoor applications often work in non-line of sight conditions, which result in insufficient precision and accuracy of derived localizations. One of the possible solutions is the…
Two-way relaying networks (TWRNs) allow for more bandwidth efficient use of the available spectrum since they allow for simultaneous information exchange between two users with the assistance of an intermediate relay node. However, due to…
A fully-asynchronous network with one target sensor and a few anchors (nodes with known locations) is considered. Localization and synchronization are traditionally treated as two separate problems. In this paper, localization and…
Optical fibers have long been employed as sensors in a wide range of commercial systems. Distributed Acoustic Sensing (DAS) extends this concept by enabling the detection and localization of acoustic sources along the fiber, using…
Accurate indoor localization is a crucial enabling technology for many robotics applications, from warehouse management to monitoring tasks. Ultra-wideband (UWB) ranging is a promising solution which is low-cost, lightweight, and…
In recent years, UWB has garnered widespread attention in academia and industry due to its low power consumption, wide bandwidth, and high time resolution characteristics. This paper introduces the design of an asynchronous IR-UWB…
6-Degree of Freedom (6DoF) motion estimation with a combination of visual and inertial sensors is a growing area with numerous real-world applications. However, precise calibration of the time offset between these two sensor types is a…
One of the most promising approaches to overcome the drastic channel variations of millimeter wave (mmW) communications is to deploy dual-mode base stations that integrate both mmW and microwave (\muW) frequencies. Reaping the benefits of a…
This paper considers target tracking based on a beacon signal's time-difference-of-arrival (TDOA) to a group of cooperating sensors. The sensors receive a reflected signal from the target where the time-of-arrival (TOA) renders the distance…
Fluid antenna (FA) technology has emerged as a promising approach in wireless communications due to its capability of providing increased degrees of freedom (DoFs) and exceptional design flexibility. This paper addresses the challenge of…
A popular method to estimate the positions or directions-of-arrival (DOAs) of multiple sound sources using an array of microphones is based on steered-response power (SRP) beamforming. For a three-dimensional scenario, SRP-based methods…
Given a network of receivers and transmitters, the process of determining their positions from measured pseudoranges is known as network self-calibration. In this paper we consider 2D networks with synchronized receivers but unsynchronized…
Localization is a fundamental function in cooperative control of micro unmanned aerial vehicles (UAVs), but is easily affected by flip ambiguities because of measurement errors and flying motions. This study proposes a localization method…
We propose a linear time-difference-of-arrival (TDOA) measurement model to improve \textit{distributed} estimation performance for localized target tracking. We design distributed filters over sparse (possibly large-scale) communication…
This paper presents a general technique for the joint Direction-of-Arrival (DoA) and Time-of-Arrival (ToA) estimation in multipath environments. The proposed ultra-wideband technique is based on phase-mode expansions and the use of nearly…
Angle of arrival (AOA) is widely used to locate a wireless signal emitter in unmanned aerial vehicle (UAV) localization. Compared with received signal strength (RSS) and time of arrival (TOA), it has higher accuracy and is not sensitive to…
Localization is an important required task for enabling vehicle autonomy for underwater vehicles. Localization entails the determination of position of the center of mass and orientation of a vehicle from the available measurements. In this…
The quick detection and localization of partial discharge (PD) in an air-insulated substation (AIS) based on ultrahigh-frequency (UHF) sensor arrays are efficient for power equipment monitoring. The adopted UHF PD time difference of arrival…