Related papers: PCI-express based high-speed readout for the Belle…

This paper introduces a high-performance Soft-Core Processor based data acquisition system designed for handling Resistive Plate Chambers (RPCs). The DAQ consist of FPGA-based hardware equipped with Soft-Core Processor and embedded…

The Compressed Baryonic Matter (CBM) experiment will investigate the quantum chromodynamics (QCD) phase diagram at high net baryon densities and moderate temperatures. CBM Time of Flight (TOF) system is composed of super modules containing…

The upcoming PandaX-xT experiment will deploy over 3,000 readout channels operating at a 500 MSa/s sampling rate, generating a sustained data bandwidth up to 1.6 GB/s. To meet this demanding requirement, we present AURORA, a…

The ATLAS trigger has been used very successfully for the online event selection during the first part of the second LHC run (Run-2) in 2015/16 at a center-of-mass energy of 13 TeV. The trigger system is composed of a hardware Level-1…

The Belle II experiment has been preparing for its first e+ e- collisions, scheduled in April 2018. With a target luminosity 40 times greater than the Belle experiment, the goal of Belle II is to open the door to a panorama of measurements…

A fast-reading current integrator is developed for high time-resolution and low-noise ion beam diagnostics under both continuous-wave and pulsed operating conditions. The system combines a low-leakage transimpedance front-end with a hybrid…

We present an FPGA-based online data reduction system for the pixel detector of the future Belle II experiment. The occupancy of the pixel detector is estimated at 3 %. This corresponds to a data output rate of more than 20 GB/s after zero…

The Belle experiment, part of a broad-based search for new physics, is a collaboration of approximately 400 physicists from 55 institutions across four continents. The Belle detector is located at the KEKB accelerator in Tsukuba, Japan. The…

A data acquisition (DAQ) system is described which will be used for the next generation of prototype calorimeters using particle flow algorithms for the International Linear Collider (ILC). The design is sufficiently generic and scalable…

We report on the charged particle identification (PID) systems for the upcoming Belle II experiment. The time of propagation counter in the central region and the proximity focusing ring imaging Cherenkov counters with aerogel radiator in…

The Belle II detector operating at the future upgrade to the KEKB accelerator will perform high-statistics precision investigations into the flavor sector of the Standard Model. As charged hadron identification is a vital element of the…

Current and future experiments at the high intensity frontier are expected to produce an enormous amount of data that needs to be collected and stored for offline analysis. Thanks to the continuous progress in computing and networking…

In high energy physics experiments (HEP), high speed and fault resilient data communication is needed between detectors/sensors and the host PC. Transient faults can occur in the communication hardware due to various external effects like…

3-D cross point phase change memory (PCM) is a promising emerging memory. However, dynamic performances of 3-D cross point PCM are limited and the role of bias scheme is unknown. Previous studies on bias schemes for planar memories use…

The Belle-II experiment and superKEKB accelerator will form a next generation B-factory at KEK, capable of running at an instantaneous luminosity 40 times higher than the Belle detector and KEKB. This will allow for the elucidation of many…

A large Time Projection Chamber is the main device for tracking and charged-particle identification in the ALICE experiment at the CERN LHC. After the second long shutdown in 2019/20, the LHC will deliver Pb beams colliding at an…

The detector readout architecture introduced in this paper is intended for small to medium size physics experiments that have moderate bandwidth needs, and applications that require an ultimately low background radioactivity for the parts…

The time-of-flight (TOF) system in the Compressed Baryonic Matter (CBM) experiment is composed of super modules based on multi-gap Resistive Plate Chambers (MRPC) for high-denseness, high-resolution time measurement. In order to evaluate…

As exascale systems reach unprecedented concurrency, traditional performance analysis tools struggle with the overhead of massive-scale telemetry. We present an accelerated infrastructure for the hpcanalysis framework that leverages a…

The trend toward specialized processing devices such as TPUs, DPUs, GPUs, and FPGAs has exposed the weaknesses of PCIe in interconnecting these devices and their hosts. Several attempts have been proposed to improve, augment, or downright…