Related papers: RF Reflectometry for Readout of Charge Transition …
The superconducting nanowire single photon detector (SNSPD) is a leading technology for quantum information science applications using photons, and they are finding increasing uses in photon-starved classical imaging applications. Critical…
Quantum state detectors based on switching of hysteretic Josephson junctions biased close to their critical current are simple to use but have strong back-action. We show that the back-action of a DC-switching detector can be considerably…
Qubit readout is an indispensable element of any quantum information processor. In this work, we experimentally demonstrate a non-perturbative cross-Kerr coupling between a transmon and a polariton mode which enables an improved quantum…
With the assistance of a single cyclic three-level system, which can be realized by a superconducting flux qubit, we study theoretically the degenerate microwave parametric down-conversion (PDC) in a superconducting transmission line…
The ability to fast reset a qubit state is crucial for quantum information processing. However, to actively reset a qubit requires engineering a pathway to interact with a dissipative bath, which often comes with the cost of reduced qubit…
The RD50-CMOS group aims to design and study High Voltage CMOS (HVCMOS) chips for use in a high radiation environment. Currently, measurements are performed on RD50-MPW2 chip, the second prototype developed by this group. The active matrix…
We study bifurcation measurement of a multi-level superconducting qubit using a nonlinear resonator biased in the straddling regime, where the resonator frequency sits between two qubit transition frequencies. We find that high-fidelity…
In this letter, we study the impact of the low-pass resistor-capacitor (RC) filter on radio frequency (RF) wireless power transfer (WPT). The RC filter influences both the RF bandwidth by removing the harmonics as well as the ripple voltage…
Designing quantum systems with the measurement speed and accuracy needed for quantum error correction using superconducting qubits requires iterative design and test informed by accurate models and characterization tools. We introduce a…
We study a dissipative Kerr-resonator subject to both single- and two-photon detuned drives. Beyond a critical detuning threshold, the Kerr resonator exhibits a semiclassical first-order dissipative phase transition between two different…
A quantum-limited electrometer based on charge modulation of the Josephson supercurrent in the Bloch transistor inserted into a superconducting ring is proposed. As this ring is inductive coupled to a high-Q resonance tank circuit, the…
In gate-based dispersive sensing, the response of a resonator attached to a quantum dot gate is detected by a reflected radio-frequency signal. This enables fast readout of spin qubits and tune up of arrays of quantum dots, but comes at the…
This work presents a switchable frequency-selective rasorber (SFSR) with two operating modes. Switching from transmission to reflection can be achieved by appropriately adding feeders and PIN diodes based on cascaded two-dimensional lossy…
The authors demonstrate readout of electrically detected magnetic resonance at radio frequencies by means of an LCR tank circuit. Applied to a silicon field-effect transistor at milli-kelvin temperatures, this method shows a 25-fold…
The demand for a fast high-frequency read-out of high impedance devices, such as quantum dots, necessitates impedance matching. Here we use a resonant impedance matching circuit (a stub tuner) realized by on-chip superconducting…
On-chip optical resonators have the promise of revolutionizing numerous fields including metrology and sensing; however, their optical losses have always lagged behind their larger discrete resonator counterparts based on crystalline…
Digital Frequency-Domain Multiplexing (DfMux) is a technique that uses MHz superconducting resonators and Superconducting Quantum Interference Device (SQUID) arrays to read out sets of Transition Edge Sensors. DfMux has been used by several…
In this letter, we describe operation of a radio-frequency superconducting single electron transistor (RF-SSET) with an on-chip superconducting LC matching network consisting of a spiral inductor L and its capacitance to ground. The…
Microwave kinetic inductance detector (MKID) provides a way to build large ground based sub-mm instruments such as NIKA and A-MKID. For such instruments, therefore, it is important to understand and characterize the response to ensure good…
The process of measuring a qubit and re-initializing it to the ground state practically lead to long qubit idle times between re-runs of experiments on a superconducting quantum computer. Here, we propose a protocol for a \textit{demolition…