Related papers: Joint Waveform and Beamforming Optimization for MI…
Massive antenna arrays form physically large apertures with a beam-focusing capability, leading to outstanding wireless power transfer (WPT) efficiency paired with low radiation levels outside the focusing region. However, leveraging these…
Considering a multiple-user multiple-input multiple-output (MIMO) channel with an eavesdropper, this letter develops a beamformer design to optimize the energy efficiency in terms of secrecy bits per Joule under secrecy quality-of-service…
Radiative wireless power transfer (WPT) is a promising technology to provide cost-effective and real-time power supplies to wireless devices. Although radiative WPT shares many similar characteristics with the extensively studied wireless…
Wireless energy transfer (WET) is a green enabler of low-power Internet of Things (IoT). Therein, traditional optimization schemes relying on full channel state information (CSI) are often too costly to implement due to excessive energy…
This correspondence studies the wireless powered over-the-air computation (AirComp) for achieving sustainable wireless data aggregation (WDA) by integrating AirComp and wireless power transfer (WPT) into a joint design. In particular, we…
Simultaneous wireless information and power transfer (SWIPT) is anticipated to have abundant applications in future machine or sensor based wireless networks by providing wireless data and energy access at the same time. In this paper, we…
We consider joint beamforming and stream allocation to maximize the weighted sum rate (WSR) for non-coherent joint transmission (NCJT) in user-centric cell-free MIMO networks, where distributed access points (APs) are organized in clusters…
The dual use of radio signals for simultaneous wireless information and power transfer (SWIPT) has recently drawn significant attention. To meet the practical requirement that energy receivers (ERs) operate with significantly higher…
Energy beamforming (EB) is a key technique for achieving efficient radio-frequency (RF) transmission enabled wireless energy transfer (WET). By optimally designing the waveforms from multiple energy transmitters (ETs) over the wireless…
This paper considers joint beamformer design towards maximizing the mutual information in a coherent wireless sensor network with noisy observation and multiple antennae. Leveraging the weighted minimum mean square error and block…
This work proposes a novel joint design for multiuser multiple-input multiple-output wiretap channels. The base station exploits a switching network to connect a subset of its antennas to the available radio frequency chains. The switching…
This letter investigates a downlink multiple input single output (MISO) system based on transmissive reconfigurable metasurface (RMS) transmitter. Specifically, a transmitter design based on a transmissive RMS equipped with a feed antenna…
A multiple antenna base station (BS) with an intelligent reflecting surface (IRS) platform, and several single antenna users are considered in the downlink mode. Simultaneous wireless information and power transfer (SWIPT) is utilized by…
This paper investigates simultaneous wireless information and power transfer (SWIPT) for multiuser multiple-input-single-output (MISO) secrecy channel. First, transmit beamfoming without artificial noise (AN) design is considered, where two…
This paper introduces a highly efficient rectenna (rectifying antenna) using a binary optimization algorithm. A novel pixelated receiving antenna has been developed to match the diode impedance of a rectifier, eliminating the need for a…
Energy beamforming (EB) is a key technique for achieving efficient radio-frequency (RF) transmission enabled wireless energy transfer (WET). By optimally designing the waveforms from multiple energy transmitters (ETs) over the wireless…
This paper studies the transmit energy beamforming in a multi-antenna wireless power transfer (WPT) system, in which an access point (AP) equipped with a uniform linear array (ULA) sends radio signals to wirelessly charge multiple…
Conventional wireless power transfer systems consist of a microwave power generator and a microwave power receiver separated by some distance. To realize efficient power transfer, the system is typically brought to resonance, and the…
In this letter, we consider optimal hybrid beamforming design to minimize the transmission power under individual signal-to-interference-plus-noise ratio (SINR) constraints in a multiuser massive multiple-input-multiple-output (MIMO)…
At millimeter wave (mmWave) frequencies, the higher cost and power consumption of hardware components in multiple-input multiple output (MIMO) systems do not allow beamforming entirely at the baseband with a separate radio frequency (RF)…