Related papers: Joint Waveform and Beamforming Optimization for MI…
In this paper, we study the average throughput performance of energy beamforming in a multi-antenna wireless-powered communication network (WPCN). The considered network consists of one hybrid access-point (AP) with multiple antennas and a…
In this paper, we determine the harvested power region of a two-user multiple-input single-output (MISO) wireless power transfer (WPT) system for a non-linear model of the rectennas at the energy harvester (EH) nodes. To this end, we…
In this paper, we investigate a multiuser relay system with simultaneous wireless information and power transfer. Assuming that both base station (BS) and relay station (RS) are equipped with multiple antennas, this work studies the joint…
Transmit beamforming is a versatile technique for signal transmission from an array of $N$ antennas to one or multiple users [1]. In wireless communications, the goal is to increase the signal power at the intended user and reduce…
Opportunistic scheduling and beamforming schemes are proposed for multiuser MIMO-SDMA downlink systems with linear combining in this work. Signals received from all antennas of each mobile terminal (MT) are linearly combined to improve the…
Multi-antenna or multiple-input multiple-output (MIMO) technique can significantly improve the efficiency of radio frequency (RF) signal enabled wireless energy transfer (WET). To fully exploit the energy beamforming gain at the energy…
Coherent communications aim to support higher data rates and extended connectivity at lower power consumption compared with traditional point-to-point transmissions. The typical setting of coherent communication schemes is based on a single…
Hybrid digital and analog beamforming is a highly effective technique for implementing beamforming methods in millimeter wave (mmWave) systems. It provides a viable solution to replace the complex fully digital beamforming techniques.…
In this paper, we investigate a multiuser distributed antenna system with simultaneous wireless information and power transmission under the assumption of imperfect channel state information (CSI). In this system, a distributed antenna port…
Wireless power transfer (WPT) technologies hold promise for enhancing device autonomy, particularly for energy-limited IoT systems. This paper presents experimental results on coherent and non-coherent transmit diversity approaches for WPT,…
This paper studies power-efficient uplink transmission design for federated learning (FL) that employs over-the-air analog aggregation and multi-antenna beamforming at the server. We jointly optimize device transmit weights and receive…
A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…
Multiple-input multiple-output (MIMO) systems exploit spatial diversity to facilitate multi-user communications with high spectral efficiency by beamforming. As MIMO systems utilize multiple antennas and radio frequency (RF) chains, they…
In this paper, we consider a dual-hop Multiple Input Multiple Output (MIMO) relay wireless network, in which a source-destination pair both equipped with multiple antennas communicates through a large number of half-duplex…
In the sixth-generation (6G) networks, massive low-power devices are expected to sense environment and deliver tremendous data. To enhance the radio resource efficiency, the integrated sensing and communication (ISAC) technique exploits the…
This letter proposes a new concept of integrated sensing and wireless power transfer (ISWPT), where radar sensing and wireless power transfer functions are integrated into one hardware platform. ISWPT provides several benefits from the…
Antennas of transmitters and receivers have been manipulated to increase the capacity of transmission and reception of signals. Using many elements in antennas to shape beams and direct nulls in a particular point for optimum signal…
In this study we derive novel optimal algorithms for joint power control and beamforming design in modern large-scale MIMO systems, such as those based on the cell-free massive MIMO and XL-MIMO concepts. In particular, motivated by the need…
This paper optimizes the beamforming design of a downlink multiple-input multiple-output (MIMO) dual-function radar-communication (DFRC) system to maximize the weighted communication sum-rate under a prescribed transmit covariance…
The robust beamforming problem in multiple-input single-output (MISO) downlink networks of simultaneous wireless information and power transfer (SWIPT) is studied in this paper. Adopting the time switching fashion to perform energy…