Related papers: Double-absorber thin-film solar cell with 34% effi…
We derive the photovoltaic conversion efficiency limit for two-terminal tandem solar cells with a perovskite top cell and silicon bottom cell with an embedded spectrum splitter. For large-bandgap top-cells a spectrum splitter strongly…
We investigate the angular behavior of the upper bound of absorption provided by the guided modes in thin film solar cells. We show that the 4n^2 limit can be potentially exceeded in a wide angular and wavelength range using two-dimensional…
In terms of mixing graded TiO2 and SnO2 powders by solid-state reaction method, ITO was prepared. Using electron beam gun technology, ITO films with different thicknesses were prepared. The influence of film thickness on structure,…
This work theoretically explores a spectrally selective TPV cell based on an asymmetric Fabry-Perot resonance cavity structure with sub-100-nm GaSb layer. The simulated spectral property of the ultrathin nanophotonic cell structure exhibits…
In this article, we theoretically demonstrate multilevel impurity photovoltaic effect in an efficient silicon dual-homojunction solar cell that ensures an extended absorption of longer wavelength light. Along with suitable contact work…
We report thin-film InAs/GaAs quantum dot (QD) solar cells with $n-i-p{+}$ deep junction structure and planar back reflector fabricated by epitaxial lift-off (ELO) of full 3-inch wafers. External quantum efficiency measurements demonstrate…
This paper proposes an efficient three-layered p-GaAs/p-CIGS/n-CdS (PPN), a unique solar cell architecture. Copper indium gallium selenide (CIGS)-based solar cells exhibit substantial performance than the ones utilizing cadmium sulfide…
We propose a solar thermal energy conversion system consisting of a solar absorber, a thermoradiative cell or negative illumination photodiode, and a photovoltaic cell. Because it is a heat engine, this system can also be paired with…
Development of alternative thin film photovoltaic technologies is an important research topic due to the potential for low-cost, large-scale fabrication of high-efficiency solar cells. Despite the large number of promising alternative…
Currently, Sb$_2$Se$_3$ thin films receive considerable research interest as a solar cell absorber material. When completed into a device stack, the major bottleneck for further device improvement is the open circuit voltage, which is the…
Carbon materials are excellent candidates for photovoltaic solar cells: they are Earth-abundant, possess high optical absorption, and superior thermal and photostability. Here we report on solar cells with active layers made solely of…
Cu2ZnSnS(e)4 (CZTS(e)) solar cells have attracted much attention due to the elemental abundance and the non-toxicity. However, the record efficiency of 12.6% for Cu2ZnSn(S,Se)4 (CZTSSe) solar cells is much lower than that of Cu(In,Ga)Se2…
A systematic survey and subsequent research have been made on MoTe2-based n-CdS/p-MoTe2/p+-CGS device in solar cell and photodetector field. The optimization has been established by altering the various properties of each constituent layer…
Ultrathin solar cells reduce material usage and allow the use of lower-quality materials thanks to their one order of magnitude smaller thickness than their conventional counterparts. However, efficient photonic light-trapping is required…
In this paper we carried out theoretical study of the general issues related to the efficiency of SiC:H/a-Si:H single- and multi-junction tandem solar cells. Implementation of numerical simulations by the use of AMPS-1D program of…
This paper presents modelled results for optical absorption in ultra-thin films of nickel, gold and silver across the solar spectrum. It is found in the case of nickel there is an optimum thickness for maximum solar absorption around…
Thin films are preferred for high photocurrent conversion efficiency, but strong photon absorption at photon energies below the bandgap (near and shortwave infrared) typically requires thicker semiconductor layers. To address this tradeoff,…
Transition metal dichalcogenides (TMDCs) have garnered significant interest in optoelectronics, owing to their scalability and thickness-dependent electrical and optical properties. In particular, thin films of TMDCs could be used in…
Intermediate band solar cells hold the promise of ultrahigh power conversion efficiencies using a single semiconductor junction. Many current implementations use materials with bandgaps too small to achieve maximum efficiency or use…
Choosing the Indium Gallium Nitride (InGaN) ternary alloy for thin films solar cells might yield high benefits concerning efficiency and reliability, because its bandgap can be tuned through the Indium composition and radiations have little…